You are using an out of date browser. It may not display this or other websites correctly. You should upgrade or use an alternative browser.
bar pressure
The split-Hopkinson pressure bar, named after Bertram Hopkinson, sometimes also called a Kolsky bar, is an apparatus for testing the dynamic stress–strain response of materials.
Hello all,
Seeking any input on a matter that seems to defy logic and common sense.
Sealed system Oil fired boiler (newish) feeding a large farmhouse from an annex with a good quality install/ pump etc that seems to be doing the job.
The system is losing 1 bar per day for a long time. I...
I would be very grateful if someone can give me some advice on the following.
I have a Worcester 28Si II combi boiler in the house where I live, the hot water side is working fine, however I have an issue on the radiator heading side.
When the heating is on the bar pressure is going very...
Hi,
Have lived in our house for around 10 years and always had bad pressure if more than one tap is running, toilet is flushed etc(hot and cold). We have (what I believe to be) a mains pressure system with a non vented Megaflow cylinder.
We are about to install a new thermostatic shower and...
I've got 4 bar on the digital display but when I've let some pressure out f75 kicks in low water sensor this is at 3 bar anyone know why this is maybe need a new sensor?
Hello - first up I am not a plumber, so am hoping that my problem is one of those really easy things to sort out if I was!
The 3 bar pressure reducing valve fitted to the cold water inlet pipe to my Heatrae Sandia Megaflow in the airring cupboard has just started to make a thumping or...
Hi all,
I had a new combi boiler installed by a gas-safe registered engineer. We moved the position of the boiler so this required new pipes be laid - and so the floor was dug up, new pipes put in, and then everything was filled with concrete again. So a relatively major operation.
The...
Newbie Simple Question - BAR Pressure
Hi,
I have a very simple question.
I can't turn my Radiator Thermostat on my Boiler above 2, otherwise my BAR Pressure needle goes into the Red.
How do I correct this? My own theory is too release some water out of the Radiators. Just want to check...
I am new to forums, but have a problem that I can't solve. First of all I am a qualified plumber including unvented systems. My 3bar pressure valve has been dripping for a few weeks now. I changed it for a new one thinking seal had gone or bit of crap has got stuck but the new one also drips...
Hi
I'm at a loss as to what the problem could be with my Logic 30 boiler.
I've had a problem which has the bar pressure dropping to zero within 2 days.
I've had the floorboards up and been crawling under the floor to check all pipework which shows no signs of leaking.
The radiators have been...
kx07fdp
Thread
anywhere
barbarpressure
boiler
leak
logic
oil
pressure
problem
water
I repressurised the system before Christmas and saw only today the pressure had dropped down to 0 bar, however both hot water and CH seem fine.
I checked the towel radiator and it seems to be the culprit as only the bottom half was hot, so bled this one and repressurised the system.
Could this...
Hello everyone
I have got a Vaillant turbomax combi boiler, Its a good 12 years old and i have just noticed that when the heating is on the bar pressure goes right off the scale. When the boiler is left off overnight the bar pressure is at 1.5 which i think is about right. With the pressure...
Hi
I have an unvented system (Santon cylinder) & noticed that the pressure when cold is over 2.5 bar. The hot water is also extremely hot. Are the 2 related & can I reduce the pressure by bleeding the radiators?
Any advice appreciated.
I had an issue with frozen pipes for the CH the last few days. Repaired a burst outside pipe and re-insulated it which seems to have thawed the freeze.
However the pressure gauge on my boiler which normally reads just under 1 bar is now at it's max, 4 bar!!! Should I turn on the CH with the...
System Saunier Duval System 400 (25 year old combi boiler)
Boiler has been making a loud thudding whoosh sound which rattles the case when firing back up during normal use. I think they call it "explosive ignition"
The Boiler was serviced by British Gas a few days ago. He told me this was...
kinlungchan
Thread
barbarpressure
boiler
boilers
british gas
combi
combi boiler
during
expansion
expansion vessel
filling loop
gas
google
high
ignition
internet
noise
pressure
problem
radiators
rattling
saunier
system
valve
vessel
hi all
i was told i would be back with a problem
about a month ago i was advised the ex vessel (which is charged to 1 bar) was knackered so fitted an external one t into the return pipe everything was running fine until i checked the pressure level then i topped it up to 1 bar then ran the ch...
seanmfc
Thread
air
barbarpressure
baxi
boiler
central heating system
cold
expansion
expansion vessel
filling loop
fitting
hot
no water
pipe
pressurepressure problem
pressurised
problem
pump
system
valve
vessel
water
We had a brand new central heating system installed with a combi boiler (worcester bosch) installed just over a year ago.
It was working perfectly.
And then we had some building work done which involved moving one of the radiators to a different wall.
After the radiator was moved, I...
mamaleelee
Thread
barbarpressure
bleed
bleeding
boiler
building
central heating system
combi
combi boiler
filling loop
insurance
leak
oil
pipe
plumber
pressure
problem
radiator
radiators
sealed
system
tap
vent
work
Sure, ad-blocking software does a great job at blocking ads, but it also blocks useful features of our website. For the best site experience please disable your AdBlocker.