Questions and plumbing advice in the Bathrooms, Showers and Wetrooms - .
Some popular plumbing forums: Plumbing Advice - Plumbing Tools - Plumbing Courses & NVQ's
I live in an apartment with a cold water tank. The cold water tank feeds the cold water tap in the sink and the bath. Recently, I refurbished my bathroom, and according to the plumber who fitted the new taps, high-pressure taps were fitted. Consequently, the water from taps is of a low volume...
Hello,
We hade a problem with our hot water not working in one of our bathroom's (all other outlets were working)
Therefore we got the Thermostatic Shower Valve changed and everything was working again.
However a few days later, both hot and cold no longer works for the bath and the hot...
Hi there
I fitted a Sanicompact 43 about10 years ago.
A few years ago i noticed that it would intermittently activate in the middle of the night so I fitted a simple pull cord swith to turn it off at night
About a month ago I recently had a blockage so pulled it apart and cleaned everything...
Hi. I get a slight leak of water in the bowl. Any advice re the attached please. Thank you in advance
I’m after some advice.
I’ve inherited my parents house. In the process of doing it up.
My dad got a Mira combiflow installed about 15 years ago. Over the last couple of months every so often when it’s turned on the water runs ice cold even if I turn the handle to hottest temp. All other taps...
Hello all,
So been having somewhat of a time with my Aqualisa Quartz 9.5 electric shower. A few.month ago I put up with a few problems it was having and in the end I replaced everything, new engine and new front cover . This was working great for a month or so, but now noticed an intermittent...
Please advise me. I am a disabled pensioner. I had a wet room fitted just over a year ago using a local authority grant. Builder was employed by local authority. I had no say in who carried out the work.
I have called the builder out under the guarantee several times for water leaks. The shower...
Hi
I have a 22mm hot and cold water supply to new bath. The pipes finish with compression valves. I need a 500 mm tap connector hose to connect with half inch thread on the new bath tap. All the connectors at the main plumb merchants are 22mm x 3/4 inch. No one seems able to answer question...
Hi, I have a stopcock in my closet at my flat, but despite me turning it clockwise all the way, this doesn't seem to be stopping the flow of water.
Is there anyway I can check if that truly is the stopcock and if not, is there a way I can find the actual one?
I just want to stop the water flow...
I have just moved into a flat and the water waste pipe from the flat above goes through our bathroom. And the water comes into room. I call the flat owner to say my problem but he don't interest him. I am there to find a talented plumber. Please reply me.
Hi all
Moved in to a new house a few months ago. The previous owner had installed an accessible wetroom with nonslip flooring, handrails, etc. We've been using it but have started to notice that some of the floor tiles make a squelching sound when you tread on them and a little water emerges...
Hi,
I hope to adjust the shower mixer tap temperature by adjusting the physical device regulator, that goes by several names/terms. I have experience of this with sink/basin mixer taps and that was straight forward. I have attached four images and seek assistance to identify what they are. Some...
I'm in the process of refurbishing my bathroom. I'll be replacing the existing bath with a walk in shower. Will be installing a thermostatic mixer valve fed by mains on the cold side and a combi boiler (Logic Combi c30) for thr hot.
Ideally what I'd like to do is have the mixer valve at the...
We recently replaced a shower cubicle in our upstairs bathroom with a jacuzzi bath and shower cubicle and took the bath water feed from the existing shower. We were in the middle of a rennovation so the bathroom hadnt been used for 6 months or so in between. We replaced the tiles with the shower...
The pipe is connecting to a 22mm tap. Why is the bottom part of the pipe wider? Can I still use a connection fitting for 22mm if I cut it at the bottom part?
Thanks🙏🏾🙏🏾
I have two toilet water valves to install. I'm new to this but have watched enough videos to think I can do it. Both water valves are standard turn off sweat valves that have been soldered on. One has at least two inches of exposed copper pipe extending beyond the wall flange and the other has...
Hi
I'm currently doing the pre-planning for my next DIY project fitting a shower tray and enclosure from scratch. I'm confident of being able to do the job but not being a plumber not sure the best way to go about it so would appreciate any advice.
The current upstairs room has a black waste...
Hi all. Sorry I'm not a plumber so go easy on me. I have a triton shower (see images) below, I don't know the model as it was here before me. Basically you have to turn the handle anto clockwise for hot water, off is the 6 o'clock position. However the handle will only go as far as between 12...
I’m doing a bathroom refit, and there’s some strange pipework design that I’d like some advice on, please.
I want to remove the cold water pipe running through the loft space because I would rather avoid having a cold water pipe buried under the loft roll insulation.
Instead, I’d like to reuse...
Hi,
Just had a new bathroom fitted and have a pathetic flow of hot water from the sink tap. It wasn't great before. I can't get hold of a plumber, but any ideas as to what this might be? I also noticed that the pipes that feed the hot tap go into the loft? I know nothing about plumbing, but is...
Creating content since 2001. Untold Media.
Tags
Newest Plumbing Threads
-
Cistern filling one third of the way
- Started by dwaindigital
- Replies: 2
-
Boiler losing pressure only on central heating- Started by SnosRap75
- Replies: 2
-
tanking. Is it ok to just seal everything with plastic.
- Started by Staggersandfalls
- Replies: 3
-
Pop quiz, does anyone recognise this radiator valve?
- Started by dimuc
- Replies: 3
-
SUsing coil to clear pipe leading to gutter
- Started by Sonya K
- Replies: 1
-
Replacing outdoor P-Trap Gully with Bottle Gully
- Started by DIwhYdidIstartThis
- Replies: 0
-
-
-
-
-
Mixer mixer shower, compatible with tanked supply
- Started by Matt0029
- Replies: 2
-
-
No Hot water, Fixed and Broken Again Ideal Logic 24
- Started by Filthbags
- Replies: 2
-
-
What's happening to this radiator, paint flaking off?
- Started by mikmikmikmik2024
- Replies: 3
