You are using an out of date browser. It may not display this or other websites correctly. You should upgrade or use an alternative browser.
rings
Fighting Network Rings, trademarked as RINGS, is a Japanese combat sport promotion that has lived three distinct periods: puroresu promotion from its inauguration to 1995, mixed martial arts promotion from 1995 to its 2002 disestablishment, and the revived mixed martial arts promotion from 2008 onward.RINGS was founded by Akira Maeda on May 11, 1991, following the dissolution of Newborn UWF. At that time, Maeda and Mitsuya Nagai were the only two people to transfer from UWF, wrestlers such as Kiyoshi Tamura, Hiromitsu Kanehara and Kenichi Yamamoto would later also transfer from UWF International.
Hi,
I need to replace the O rings on the spout of my kitchen tap.
What lubricant do I need to use in order to aid fitting the new O rings.
Searched and failed again!
Servicing a Riello burner and noticed a weep of fuel from under the pump. When I checked, the O ring under the pump filter cover was hard, like plastic.
Do you guys normally change these, as a matter of course, during a service?
Morning all.
I am running some 22mm copper later today, I normally use Talon clips from screw fix, as you can add on spacer blocks for the gap, what other plastic clips do you uses, recommend? I have some munsen rings for an outside run.
Thanks in advance!
Hello, my Blanco 5300 Eye kitchen taps is leaking. I have replaced the cold valve 3 times (so 4 valves in total). After each time I replace the valve, the tap stops leaking for a year, then it starts again. This time, I changed the valve a few weeks ago and already it has slowly started a drip...
Just been called out to a heatslave 20 25 old but in good knick.
Call was for the heating coming on when it is off on the prorammer.
Typically it wont do it while i was there!!!!
Any ideas????
Thanks
Dear all;
Hoping you can help. Our Hydramax shower (this one: AQUALISA HYDRAMAX Exposed shower valve Spares and Spare Parts) is leaking from a small hole underneath. This seems to be a pressure relief valve?
However I just checked and even if I cover this with my finger, water is spewing out...
Hi,
the gooseneck spout on my Franke Triflow Doric taps has seized, and the spout can no longer be turned.
Franke helpline advise that it was likely that the o-rings had started to disintegrate and were jamming the goooseneck preventing it from turning, and recommended that I buy the...
Wibs
Thread
franke
mixer
problem
removing
replacement
rings
screw
spout
tap
taps
HWOS have more than doubled their price now from 42p each to 90p each! I just found this:
Riello G5/RDB (RBS31) Combustion Head/Blast Tube O Ring Pack 3007178 - Buy Plumbing Online
Price includes shipping!!
We have swan-neck swivel taps in the kitchen and within a couple of weeks, the swivel becomes very tight. I take them apart and administer silicone grease to the O rings and we are ok for another couple of weeks. It strikes me that some form of permanent lubrication would be better and I am...
Need to run two 28 s in a cold garage and support them on clips from a bison ceiling then lag with the big laggin . Whats the best way ? plastic clips wont allow for the size of the laggin so is it just best to add a copper pipe spacer on the screw or is there a better way ?
Hi All,
i have a customer that has a Grohe automatic 2000 that is leaking from the shower head. I have found a place to get a new thermostatic cartridge but they also sell 2 oring sets? Question is do i go for the o rings from grohe? Are they the sort of company that have there own size o rings...
I'm thinking of putting together a kit containing a selection of common gaskets used in oil boilers including stuff like Danfoss and Riello pump pressure screw o-rings, pump cover and filter seals, flow switch o rings, heat exchanger fibre washers etc, a bit like the Holdtite washer boxes idea...
Has anyone got an idea the best place to get O rings for sink and basin traps? I need packs of 10 preferably. So as to cut down on cost and repeat purchases. Thanking yous for your assist:yes:
Hi Folks,
I've a customer who has a slight weep on a TF1 where it swivels. Having not removed one of these before (only used magna cleans) is it serviceable or should I bin it and stick a new one in?
Cheers.
has anyone done the plastic hydro block on the glowworm flexicom the last one I passed to group service as it looked a pain - got one that's weeping had a quick look but the 2 retaining screws seem unaccessible from underneath due to the boiler jig base - should I do or pass on
Hiya All,
I'm hoping somebody can give me some advice please.
I've got a Franke Mythos mixer tap with a leak at the base of the spout. I think the fix is to replace the O ring kit.
But having removed the spout I have no idea where (or how) the new O-ring bits and pieces might fit on...
In the...
Tim_Brighton
Thread
franke
help
help needed
needed
removed
rings
spout
where
Hello All
It's 03:30 in the morning I have just joined and this is my first post. I have just given up in replacing a ceramic disc cartridge which I thought was going to be pretty straightforward but has turned in to a complete nightmare.
I have a KWC Domo single lever swivel spout kitchen...
TapsDMC
Thread
cartridge
ceramic
leaking
replaced
rings
spout
still
tap
Sure, ad-blocking software does a great job at blocking ads, but it also blocks useful features of our website. For the best site experience please disable your AdBlocker.