You are using an out of date browser. It may not display this or other websites correctly. You should upgrade or use an alternative browser.
taps
"Taps" is a bugle call during flag ceremonies and at military funerals by the United States Armed Forces. The official military version is played by a single bugle or trumpet, although other versions of the tune may be played in other contexts (e.g., the U.S. Marine Corps Ceremonial Music site has recordings of two bugle versions and one band version). It is also performed often at Girl Guide, Girl Scout, and Boy Scout meetings and camps. The tune is also sometimes known as "Butterfield's Lullaby", or by the first line of the lyric, "Day Is Done". The duration may vary to some extent.
Hi, had a new pressurised system put in about a year ago...long long story bu the guy whom put it in does not have the greatest aftercare available...lets leave it at that!
Anyway, all is working fine with the exception of when the taps have not been used for a short while, if you turn them on...
Hi,
I have had a new unvented system installed. When the hot water has been heating up for some time and I turn on the taps or the shower I get a loud noise lasting a few seconds from the cupboard where the tank is. If I turn the taps off again soon afterwards I get a similar noise. This only...
Hi I've got a couple of Basin taps to replace, once again they are old 1970's taps. I've never replaced basin taps before. I've got a basin wrench, I'm presuming you undo the holding nut, then undo the nut from the pipe to the tap thread. Then take the tap out, do I have to put anything on the...
Hi I am reusing an old cast iron bath but when measuring the distance bettween center of tap holes the results came out 7.5 inch (190mm). I notice all the mixers with attachments are usually 180mm so will I just have to settle on single taps or can I buy 190mm mixers?
Hi all...new member here, hoping someone can help!
I have slow running water from my upstairs taps.
The house is a 1980s build with a cold water tank in the loft.
I have had this problem several times and am able to cure it by connecting a hose to the tap and sending mains pressure back up...
Dear All,
After turning off taps or after the toilet completes filling the cistern, there is a loud metal clunking sound coming from pipework.
I have drained all the water from the pipes twice to get rid of water hammer. This helped stop the sound for a few weeks but the sound always came...
James johnson
Thread
after
clunking
filling
metal
oil
sound
stops
tap
taps
toilet
turning
Every time the neighbours use their water it vibrates and visibly shakes mine causing a slam when they shut off .
Shared mains with separate internal stopcock .
Is this usual?
Any solution to prevent this?
Driving me potty
Thanks
I have a system boiler and have recently had some building work completed which required the mains and the kitchen supplies to be moved. The plumber that carried out the work advised that he has replaced like for like with the pipe work so that should no cause any issue.
Of late the...
Hi,
Home had VERY low water pressure or flow before.
Had a pipe or joint burst where our feed comes into the house, via old iron pipework. We got someone out to fix it.
They found a rubber washer jammed inside a plastic joint where the iron or lead pipe from outside met the copper pipes below...
Hey guys, I’m not completely up to speed on water regs, but what type of check valve has to be fitted on mixer taps that mix in the spout?
Double or single?
Thanks in advance
Hi all, I have a standard condensing boiler fitted in 2013, BG 330+ I think.
Trouble is dirty water is coming out of taps in bathroom. Small little black flecks.
Also since this boiler was installed I've become disabled and also looking to get it changed to a combi for instant hot water what...
I've just been replacing the ceramic valves in our bathroom taps and the little plastic indices have broken so I'd like to know where I can get replacements that don't cost silly money, if anyone knows a place.
I tried Ideal Standard and they want a stupid amount for two little plastic bungs.
I...
Hi again,
My old combi boiler (Boulter Buderus Camray 5) has the central heating working OK following recent attention.
However, now the water to the taps and showers only runs lukewarm for a few seconds then goes cold. The burner kicks in and the 'clicking' and flow light seems to activate as...
Can anyone identify these taps? They are leaking and I can find no way to get at the cartridge. There are no grub screws. The pix show the whole kit plus 2 closeups 1 with the rear collar slipped off. Thanks in advance.
Hi,
I'm installing new combi taps on my bath
Swirl Period Deck-Mounted Lever Bath/Shower Mixer Tap | Bath Taps | NoLinkingToThis
Would this flexi hose be suitable - the inlet pipe is 21mm
Flexible Hose with Valve 22mm x ¾
cheers
Brendan
I've an old 'Shetack' spanner which I've never used for years, also got a 1/2 & 3/4 Monument 'hook' jaw spanner which is badly worn and slips. According to Monument you can't get replacement 'hooks'. I've also got a Rothenberger telescopic version which I've found useless except being spring...
Hi, I am about to buy a wall mounted water fall basin tap, and a builder warned me to be careful as a lot of them are "very low quality" and he's had to replace quite a few. Not sure how correct he is, but I shopped around and saw many different sellers on amazon, ebay and various online shops...
Hi there,
I live in an old 70s council block and I have been told that these taps are the original fixings. They are leaking so I assume a washer needs to be replaced but my plumber said it can't be done with this type and we need to replace the taps completely which would require ripping out...
Sure, ad-blocking software does a great job at blocking ads, but it also blocks useful features of our website. For the best site experience please disable your AdBlocker.