You are using an out of date browser. It may not display this or other websites correctly. You should upgrade or use an alternative browser.
chase
JPMorgan Chase Bank, N.A., doing business as Chase Bank or often as Chase, is an American national bank headquartered in New York City, that constitutes the consumer and commercial banking subsidiary of the U.S. multinational banking and financial services holding company, JPMorgan Chase. The bank was known as Chase Manhattan Bank until it merged with J.P. Morgan & Co. in 2000. Chase Manhattan Bank was formed by the merger of the Chase National Bank and the Manhattan Company in 1955. The bank merged with Bank One Corporation in 2004 and later acquired the deposits and most assets of Washington Mutual.
Chase offers more than 5,100 branches and 17,000 ATMs nationwide. JPMorgan Chase & Co. has 250,355 employees (as of 2016) and operates in more than 100 countries. JPMorgan Chase & Co. had their assets of $2.49 trillion in 2016.
JPMorgan Chase, through its Chase subsidiary, is one of the Big Four banks of the United States.
What is the recommended way to conceal a 1.5M, 40mm shower waste pipe? We have 30mm gap behind the plasterboard which will be renewed. Would you chase the block 10mm or go into the concrete floor?
What are the safety concerns of doing either?
Thanks.
Hi all.
I am in desperate need of a second opinion.
I have two pipes (hot and cold water) that once ran down from the bathroom above and round a corner to our sink. Previously they were in a box in but the wall they were boxed into has been removed and now we are left unsure what to do now...
Looking for feedback on any code restriction that would restrict using inner section of metal I beam as a chase for 96% efficient pvc exhaust and intake. I can’t find anything restricting the use of it as such.
Hi again
Second belfast sink related question, but different enough from the first to require a new thread...
Our preference is for the sink to be mounted in a corner, and for the pipes to be chased in for wall mounted bib taps. Presumably that means having enough room in the chase for the...
If installing a vertical gas pipe in a wall chase. And fully encasing after. Do most people try and avoid the perks joints in the wall? As they are not always fully sealed with mortar. Or maybe its just the new build site I work on there not. Thanks for any thoughts.
Customer wants this rad replaced and the pipes chased in to the wall.
Pipe is very close to the switches but can be moved over slightly to get away from the cables.
What do you reckon? Worth doing?
Will have to cover the pipes I know to protect them.
I have said to the customer that I will...
Hi new to forum, can any one see a problem running 15mm polyfit
Dhw &cold pipes in conduit (with>50mm separation gap)in chase in slab, then covered with 75mm insulation and ufh pipes and screed on top. Thinking is put in chase to keep cold water pipes from warming from ufh pipes. Would be...
What is the maximum depth you can go when chasing a pipe in to a wall? What does it mean by leaf when talking about cavity walls?
Vertical chases should not be deeper than one-third of the wall thickness or in cavity walls one third of the thickness of the leaf
If a buildings reg. certificate says the gas work has been carried out by a person "on behalf of" another company, who do I chase for support / advice?
I was under the impression when I had my boiler fitted that the plumber had his own company, his name was on the paperwork when it came through...
dessie
Thread
boiler
chase
company
fitter
installation
registered
How deep should plastic pipe be chased into a internal brick wall with plaster finish?
I have plastic 15mm JG PEX pipe which I want to chase into wall.
How deep should I make the chase.
Do I also need to sleeve the pipe. If so what with?
Do I cement the chase or just plaster?
Thanks in...
I've just started a new bathroom/shower project and the customer has changed their mind and given me a new layout. Basically, everythings changed accept for the loo !
As you can see from the attached picture, the towel rail (which used to be where the new basin will be) is now sited on the end...
howdy all
Just wondered when chasing out to run 15mm pipes in a wall do i keep the width to a minimum and should the pipe be sleeved in anything? I dont have a fancy electric chaser so i was also wondering what the best tool would be to use with the hammer. ie bolster or smaller chisel.
Cheers
Hi all just a quick question.
If you've quoted for a boiler swap on the Monday and you haven't heard anything for a week or so do you follow it up with a phone call or email or not bother? I only ask because I'm sure I've missed out on jobs because guys are ringing up to see if their quote has...
What sort of tape should be used when a pipe is chased into a wall and plastered over. Denso, seems a little extreme, is something like pvc electrical tape ok, or is there something better
cascas
Thread
chase
corrosion
electrical
pipes
protect
tap
walls
which
Just planning a kitchen. Usually a combi fitted into a kitchen has the pipes from the bottom put through the worktop and boxed in. The layout I am working with is a bit of a pain, and I have little choice but to put the dishwasher below planned location for the boiler. At the moment neither can...
hi, ive recently passed my ccn1 and special modules and started a new job but cannot currently undertake any gas work because i have not recieved my certificate. My question is does anybody know where the exam papers are sent so that i can chase them up and speed the process up. Hope that makes...
awhitfield
Thread
chase
exam
gas
gas engineer
gas safe
gas safe register
gsr
papers
phone
process
safe
their
where
One of my friends who is a qualified plumber came round mine and said he would fit a shower.we picked out this one Buy Cascade Thermostatic Bar Mixer Shower. at Argos.co.uk - Your Online Shop for . and said it would be fine as we have a low pressure hot and cold type boiler.well iv been...
sunzzofman
Thread
boiler
building
cable
ceiling
chase
cold
cold water tank
convert
copper
hot water
install
job
jobs
london
mounted
pipe
plumbing
pressure
screw
shower
spout
surface
towel rail
wall
water
website
work
customer has bought a new bathroom suite from b&q the old bath i measured and is 166cm new bath is standard size 170cm i know i will have to chase it in by 4cm ish, seems a lot to chase in i cant chase in from the tap end for obvioues reasons any ideas.
Sure, ad-blocking software does a great job at blocking ads, but it also blocks useful features of our website. For the best site experience please disable your AdBlocker.