Vaillant Ectec 824 flow restrictor?

[Scott_D]

Fitting one today and its only letting 7.8 LPM through
I know its only a 24kw but its a bit pants

Is there a flow restrictor that can be removed or changed? I cant see anything in the MI's about it

 

[dancinplumba]

You should know, you're fitting it

 

[Scott_D]

It only shows a filter on the incoming cold in the MIs
No mention of a restrictor, cheers though:95:

 

[dancinplumba]

Could filter be blocked ?

 

[Scott_D]

I will try that tomorrow, ran out of time today.

 

[dancinplumba]

Guess the cold has good flow

 

[Scott_D]

Its about 10 lpm with a flowcup so not great but better than the hot
Its a combi swap from an old 24kw Worcester.
I measured the cold flow when quoting but never tried the hot so it might have always been crappy

I will give vaillant a call in the morning and see if there is a restrictor

 

[dancinplumba]

Check filter first, could be resistance of boiler even if only 10 lpm. At least it will be a hot 7 lpm

 

[Scott_D]

It was knocking it out at 65 :blush5:

 

[bigads28]

It's on the cold inlet just after the isolation valve.

 

[Scott_D]

It's on the cold inlet just after the isolation valve.

The filter?

 

[IDCHAPPY]

Yes, but it's a fixed in item IIRC. You can't change it for a bigger one.

 

[IDCHAPPY]

Out of interest, is it a ground floor gaff?

 

[Scott_D]

Its an older house
I advised they need a new stopcock, they have two that dont work and probably causing the low flow

 

[Leo21]

Am I being thick here, but iff youve only got 10 on the cold, your not going to get 10 out with restrictions. 7 sounds about right for the conditions. There's a lot of restrictions through the boiler, specially the hex.