Spillage on inside of case (Worcester Greenstar 24i System, 2001)

[cr0ft]

Went to this boiler today to service for the first time and found black spillage marks all over the inside of the outer case (mostly inside the airbox seal area but not all, some are clearly visible outside the seal).

Noticed there is a case screw missing on bottom left so am going to replace that and the airbox seal. Anything else obvious to look at? Combustion analysis readings are all within acceptable limits.

Is this common for these boilers? Never seen it myself before.

 

[ShaunCorbs]

common heat damage, i would say 8-10 years old?

 

[Last Plumber]

It's just heat and dust by the look of it.

 

[Scott_D]

Has it got the kebab HX?

 

[quality]

If that was spillage it would be black bright (pardon the pun)

 

[townfanjon]

Another one for heat / dust

 

[cr0ft]

On closer inspection the case is missing one of the retaining screws on the bottom left (couldn't see it till I came to put it back on, hidden by boxing) and it's not sealing properly onto the air box. Going to replace the case screw and fit a new seal just to be safe, both cheap parts. Cheers all.

 

[cr0ft]

Has it got the kebab HX?

Yes.

 

[Vee]

Watch out for a failed burner gasket (red) at the top of the heat exchanger. Even if the values are fine this could be leaking. There is a recommendation from Worcester to change these periodically, bit like the circular one on Vaillant. Not sure of the interval.
By the time it’s leaking fully you could get total meltdown on the other plastics particularly the fan. (Expensive)

 

[cr0ft]

Thanks mate