Discuss Commercial tools? in the Plumbing Jobs | The Job-board area at PlumbersForums.net
Don't normally use compression on 54 mm but Stilsons 24-36" anything bigger compression wise is different and has bolts instead of one nut (like a flange)
but it press or soldered normally
But most is like domestic but bigger
You can hire threading machines from bss etc have a look on the rems site
i get you, yea so your using a female gate valve / lever valve and using male irons to connect to copper etc
and yes or if you want to spend the cash
Knipex 86 03 400 Pliers Wrench XL Adjustable Spanner 400mm | eBay
what you using on the threads loc 55 or 557?
Loc 55 and boss white
Ā£100 for a pair of grips lol.
Yes it's just domestics.
Hmm. I'll have to check what paste we're using on the job just to be sure, but yes it is hot and cold.
Is the copper thread liable to cross if tightened to much? I'm just thinking that copper is quite soft
as above your more likely to snap the fitting
Or your wrist..
Is the copper thread liable to cross if tightened to much? I'm just thinking that copper is quite soft
What stilsons would you guys recommend?
Ridgid
did you find out what boss you were using mucca?
Yes mate. There's a couple on site. Theirs boss green and jet blue.
I have a bad habit of calling most joint compounds boss white for some reason.
Any recommendations for wide jaw adjustables? Like 42mm and above
Any recommendations for wide jaw adjustables? Like 42mm and above
Reply to Commercial tools? in the Plumbing Jobs | The Job-board area at PlumbersForums.net
We get it, advertisements are annoying!
Sure, ad-blocking software does a great job at blocking ads, but it also blocks useful features of our website. For the best site experience please disable your AdBlocker.