Search the forum,

Discuss Beer can repair, recycle, reuse in the Plumbing Jobs | The Job-board area at PlumbersForums.net

dancinplumba

Esteemed
Plumber
Gas Engineer
Subscribed
Messages
7,272
wonder how long this will last, No plastic in this cistern :):)
46101456_10215428248073771_6647021765316837376_n.jpg
46076575_10215428248393779_342704412734521344_n.jpg
46134644_10215428248713787_7155295831577329664_n.jpg
 
That’s still working .. impressive mate. Have you ever thought about of refurbishing it properly with fresh paint ? A customer has done it amd it looks real awesome though even though I’m not a fab of stuff like this
wants paint stripping off, but customer not that bothered, just wants it working, told him it's a work of art, he just laughed and said i can have it if i want
 
wants paint stripping off, but customer not that bothered, just wants it working, told him it's a work of art, he just laughed and said i can have it if i want

I have a high level cistern to try to repair. It is thought to be Victorian.
Going to be interesting.
Think I have a photo of it somewhere.
Also got stored an all copper high level cistern with brass siphon.
 

Reply to Beer can repair, recycle, reuse in the Plumbing Jobs | The Job-board area at PlumbersForums.net

Similar plumbing topics

Copper pipes, I think its fair to say, is not what it used to be, the copper is getting thin while the cost is going up. Meanwhile, plastic Pushfit seems to be getting better and better, cost and convenience was always better, but now the quality is to, have we reached a stage where plastic will...
Replies
2
Views
252
Hi. I need a new toilet supply line but don’t know the size type of the fitting at the shut off valve. It is not 3/8 compression. It is a plastic nut about the same size as the one going into the cistern but has a different thread. Attached is a photo. Can you advise. Thanks.
Replies
2
Views
189
I was stupid enough not to check the position of the pipes under the tiles when installing a toilet and drilled right through the center of a 16 mm copper water pipe. I exposed the pipe by removing a ~30cm section of the plastic sleeve and a ~10 cm section of the pipe around the hole. Several...
Replies
0
Views
189
IS IT POSSIBLE TO ADJUST THIS MIXER UNIT? WE HAVE TO HAVE IT TURNED ALMOST FULLY ANTI CLOCKWISE TO GET HOT WATEROUT. THE FRONT PLATE WITH MIRA ON IT PRISES OFF AND INSIDE THERE ARE SOME PLASTIC BITS AND A SMALL CROSS-HEAD SCREW IN THE MIDDLE. THANKS
Replies
6
Views
227
Recently had a Viessmann Vitodens combi boiler installed, quite often when the adjacent cold mixer tap is opened the boiler starts for a few seconds! Can anyone tell me what is causing this? And how to cure?
Replies
3
Views
204
Creating content since 2001. Untold Media.

Newest Plumbing Threads

Back
Top
AdBlock Detected

We get it, advertisements are annoying!

Sure, ad-blocking software does a great job at blocking ads, but it also blocks useful features of our website. For the best site experience please disable your AdBlocker.

I've Disabled AdBlock