Search the forum,

105he

The Wright R-1820 Cyclone 9 is an American radial engine developed by Curtiss-Wright, widely used on aircraft in the 1930s through 1950s. It was produced under license in France as the Hispano-Suiza 9V or Hispano-Wright 9V, and in the Soviet Union as the Shvetsov M-25.

View More On Wikipedia.org
  1. R

    Baxi 105HE

    Is it possible to change a Baxi 105HE expansion vessel without taking the boiler off the wall?, My boss said you can do it, however im doing the job so i would like some advice?
  2. M

    BAXI 105HE Combi - Minor Leak on Heating Flow Pipe (out)

    I've found a minor leak within the boiler, which I think is on the joint between the heat exchange unit and the Heating Flow (out) Pipe. I have a couple of questions really. 1) If I turn off the Heating Flow and Heating Return taps, will that stop any further leakage in the boiler. Obviously...
  3. C

    baxi 105he no hot water to furthest tap

    Hi i have gat a baxi 105he . There is hot water to all taps in the house apart from the kitchen tap with is cold . i did manage to bring the boiler on once with the tap open fully. But it used to work with tap half open... Any ideas
  4. E

    Baxi 105HE expansion vessel

    MIs says it requires a 160ml expansion vessel on the incoming mains after the check valve, which id say is quite small... anyone know the best place to get one???
  5. L

    Baxi Combi 105HE - CH Problem

    I have a Baxi Combi 105HE - The water is getting hot OK ie when I turn the water tap on the boiler fires up and produces hot water as normal. However, I am having problems with the CH. The thermostat is remote electrically operated and I can hear the click as I turn the wheel - about 16 degrees...
  6. P

    What are your top five boilers ?

    Hi guys, if you were working on a new installation using the exciting pipe work which was already in place, and the propherty layout was as follows hallway, front room, kichen, and three bed rooms and bathroom, i would like to know what would be the top five boilers installers would consider for...
  7. T

    Baxi 100 HE condensate trap causing flame failure

    How to test a Baxi condensate trap. This condensate trap is used in a number of Potterton boilers as well so I understand and it can be the cause of a flame failure lockout. Baxi will tell you to disconnect the white wire by the fan and if the boiler runs it's a damp trap.... Well it would...
  8. stings27

    Baxi 105HE

    Have a problem with a Baxi 105HE. Intermittant firing on HTG/HW Fan/flue neon flashing- checked both , seem ok. Thanks
  9. A

    baxi 105he

    been to do a service today on the above boiler with my boss, boiler had not been serviced in 5 years since it was installed, customer mentioned his hot water was taking ages to heat up same with ch, anyway when we came to fire it up, the fan fault/flue blockage light came on, after all the...
  10. D

    Main 24HE flame failure

    Hi went to a Main 24 he today (very much a B rated baxi combi HE) Boiler works fine 50% of the time. There is a fault on CH & DHW mode which is as follows; Pump runs, primary flow swith operates, fan runs at full speed but there is no atempt at igniton, then flame failure light comes on...
  11. B

    bad news

    bad news lads all band b,s go from august that means bye bye 105he,performas and main 30 /24 he the good news theres a new 105 on the way n ow if it has the normal 105 controls with the duotecs heat exchanger that will be a cracking combi
  12. E

    Grey area

    in my travels i have come across a few condensing combi's mounted on plywood, and gas safe havnt given me a definitive answer on weather this is AR or NCS what do you guys think?
  13. P

    Potterton Performa 24 - Poor H/W delivery

    I am an installer, who has been asked to repair a friends boiler. Initially, primary flow pin on diverter wasn't lifting & APS wasn't making, so changed diaphragm & APS, followed by complete diverter valve, only to discover that despite the pump rotor spinning (and heat being dissipated)...
  14. M

    Baxi 105he dhw luke warm

    hello all dhw on a baxi 105he not reaching temp, the standing gas pressure is correct at 20mb but only reaches 15mb when the hot tap is on full, I think this indicates a thermistor problem can anyone please tell me if i'm right, I took it out and cleaned it but no change any advice is much...
  15. R

    main

    any views on the main combi he30, pros cons anyone who's fitted them and prices. cheers.
Creating content since 2001. Untold Media.

Newest Plumbing Threads

Back
Top
AdBlock Detected

We get it, advertisements are annoying!

Sure, ad-blocking software does a great job at blocking ads, but it also blocks useful features of our website. For the best site experience please disable your AdBlocker.

I've Disabled AdBlock