You are using an out of date browser. It may not display this or other websites correctly. You should upgrade or use an alternative browser.
105he
The Wright R-1820 Cyclone 9 is an American radial engine developed by Curtiss-Wright, widely used on aircraft in the 1930s through 1950s. It was produced under license in France as the Hispano-Suiza 9V or Hispano-Wright 9V, and in the Soviet Union as the Shvetsov M-25.
Baxi 105he fault code blocked condensate trap? Removed terminals disconnected the pipes undid fixings removed trap and gave it a good clean out then refitted? Boiler still showing same fault code after a lot of head scratching I changed the terminals over from there original positions on the...
hi to anyone that can help
the above boiler has been fine until Friday last week when the ch stopped working the boiler fires up then after a min it shuts down the heating light is on and the temperature lights are on to max but no heating, run some cleaner through for a week and it came out...
Hi there, bit of a hot water issue (or more lack of it) ever since I installed a new bathroom a few months ago. When the hot water tap is fully open the boiler heats the water as normal but intermittently the gas cuts out for 10-15 secs until the water cools back to 60 degs and then fires up...
Hi all. After experiencing issues with luke warm hot water and reading about the relative simplicity of refurbishing the diverter valve in the Baxi 105 he I went ahead and did the job (with some trepidation)
To my relief the boiler is now working much better, however it is also leaking a fair...
hi guys. I came across a Baxi 105HE today and was trying to figure out whether the flue position was within MIs. I’ve attached a picture but looking in the book I can’t see an issue. Any advice will be appreciated.
My boiler keeps stalling. If I wiggle the wires on a micro switch. It restarts. Have ordered a new switch but concerned it may be the (igniter?) Valve below.any advice please?
Hello all.
I’ve got a problem with 105he driving me mad.
When you switch boiler on and set heating demand the pump starts for 1-2 seconds then clicks out, then starts again, then clicks out again, then starts again, over and over again.
I’ve done whole lot of electrical tests. I phoned...
hi, ive got a baxi 105 he that's heating the rads when calling for hot water, but no hot water. i changed both the diaphragms on the diverter valve, didn't fix it. I see that both 'pins' operate the micro switches. any ideas?
thanks
Hi Baxi 105HE stopped working today got fault indicator on front panel flame failure/blocked condensate pipe. I disconnected the white wire on top of the condensate trap and boiler works fine. Trap looks full of muck. Question is can I take this trap off and clean it out myself and would this...
My Baxi 105HE is seemingly on its way out. I'm not keen on another Baxi based on the relatively short life of current boiler.
Are there any boilers that can be fitted to the pipework of the 105HE without too much work .
Thank you
About every 12 - 24hrs the boiler cuts out. Leave it for about 20mins and then turn knob to off and back to CH and fires up. Try too soon and it doesn't work.
Diverter valve was replaced a couple of months ago but this fault started beginning of November. Some enquiries have pointed at the...
Hello
It could probablt take all night to type the different issues i have had/having with this boiler but the most pressing on is a Flame Faliure light. It can be reset but i can hear ignition going but nothing happens and the light come on again.
Now this ONLY works for the central heating...
markmajor
Thread
105he
baxi
boiler
central heating system
light
problem
qualified
water
Hi.
I'm working on this boiler and the fault code is 30 and 50.
Ive cleaned the venturi out. Air pressure switch clicks on. Fan runs fine. Anything else I can check?
It works for a few days then fault appears again. I'm going back there now to check if the air pressure switch power if...
HI my dad has a problem with his baxi combi 105he, it's been trouble free for around 7 yrs but now appears to cut out before reaching the thermostat temp. The radiators are not getting hot. In summary
1. CH thermostat requests heat, boiler comes on for around 5 mins then cuts out
2. Boiler...
Getting high emissions on a Baxi 105HE, a full strip down has been carried out but then found that the secondary heat exchanger seal behind the plastic connection had failed and was leaking condense back in to the boiler.
So, I replaced the entire secondary heat exchanger today but still...
Hi" folks I am new to this site and was wondering if anyone could help me with my boiler problem,s.
this is how it all started, my boiler was loosing pressure and had to be topped up every day, thought I solved the problem by repairing a split pipe,this seemed to cure fault for about a week then...
Wjl52
Thread
105he
baxi
boiler
combi
expansion
expansion vessel
pressure
problem
replaced
vessel
water
Ok guys Iv hit a wall with this boiler. Baxi 105HE poor hot water, only lukewarm but choke tap down and it gets warmer but not exactly 'hot'. Pressure was quite poor as well. Iv checked the cold inlet for any blockage but was fine so I changed the plate heat exchanger which sorted out the...
Sure, ad-blocking software does a great job at blocking ads, but it also blocks useful features of our website. For the best site experience please disable your AdBlocker.