Search the forum,

Can I get new innards for this...

Post new thread

Discuss Can I get new innards for this... in the Plumbing Jobs | The Job-board area at PlumbersForums.net

M

mutley racers

Esteemed
Plumber
Gas Engineer
Subscribed
Messages
5,172
The valve has snapped inside so would like to just get a new tap and use the innards.

20181211_152222.jpg
 
Is that tap head a left-hand thread onto the tap body? If not a left-hand thread, then there's a reasonable chance you can fit the head from a new stopcock.

If it is a left-hand thread, then I'm not going to say you won't be able to use the spindle from a modern tap, but I will call it a long shot. Not aware of where you would get a left-hand taphead from.

Good luck. Let us know how it goes!
 

Reply to Can I get new innards for this... in the Plumbing Jobs | The Job-board area at PlumbersForums.net

Similar plumbing topics

C
How to identify dripping tap.
Our kitchen mixer tap has started dripping. Like so much of the plumbing in our almost new build bungalow, it is lacking! The plumber didn't install any isolating cocks in the H&C feed to the tap so how can I identify which of the valves is passing? Shut the whole H&C water system down?
Replies
12
Views
319
Timmy D
T
johndave
Outdoor stopcock doesn't fully close
Hi all I'm hoping someone can shine a light on this for me Since our stop tap on the pavement has now been filled with sand for whatever reason, we are relying on our property fitted stopcock (this is outside on our garage wall) Unfortunately turning this to the closed position only reduces...
Replies
3
Views
241
exedon2
exedon2
D
Extending outdoor tap and drain
Hello all, I'm would like to extend an existing outside tap to another point in the garden. I'm about to pour a concrete patio and was hoping to run the water line underneath. There are existing drain (and who knows what) pipes running along the same wall so I'm nervous about digging too far...
Replies
6
Views
226
DIwhYdidIstartThis
D
P
LCS to new water mains
Hi, I have an old steel water mains pipe (approx 45mm) that I need to connect to a new pehd water mains (25mm). I can't get at it to create a new thread so what's the best way of connecting the two? Cheers, Peter
Replies
2
Views
193
ShaunCorbs
ShaunCorbs
P
Repeated Airlock in Bathroom
Hi, Can anyone advise as to why the cold water to my bathroom keeps airlocking? This originally happened about 12 months ago and has happened 3-4 times since. It’s an upstairs bathroom, fed from a tank in the attic. The tank is about 8 Meters away and feeds a bath, sink and toilet. The tank...
Replies
9
Views
318
Chuck
C
Creating content since 2001. Untold Media.

Newest Plumbing Threads

Back
Top
AdBlock Detected

We get it, advertisements are annoying!

Sure, ad-blocking software does a great job at blocking ads, but it also blocks useful features of our website. For the best site experience please disable your AdBlocker.

I've Disabled AdBlock