You are using an out of date browser. It may not display this or other websites correctly. You should upgrade or use an alternative browser.
mains
Davidson's Mains is a former village and now a district in the north-west of Edinburgh, Scotland. It is adjacent to the districts of Barnton, Cramond, Silverknowes, Blackhall and Corbiehill/House O'Hill. It was absorbed into Edinburgh as part of the boundary changes in 1920 and is part of the EH4 postcode area.
Locals sometimes abbreviate the name to D'Mains.
I live in an apartment block where generally hot water is supplied from the communal hot water cylinder and cold water to bathrooms is supplied from cold water tanks in the loft. It is a vented system. However, in a basement flat and a ground floor flat cold water supply to bathrooms is...
I need to change my shower mixer and I have a unvented hot water cylinder. Is it sufficient to turn off the mains? Do I need to drain the cylinder?
Thanks
I have a dead 1990s Triton T70 shower and, for purposes of replacement, I'd like to know if it's mains or gravity fed. As it won't even switch on, I cannot get any water out of it so I can't just switch off water at mains and see if water still flows from the shower. I note that current Triton...
Hi all,
Got a strange grating noise when the mains water is running in a property I'm looking after. It's a ground floor flat, with a first floor flat above it, and both share the same mains water pipe, and I believe the stopcock behind the washing machine isolates all water to both properties...
I've had an idea to use a gas fired generator running on mains gas to top up a large off grid battery bank when solar power is insufficient. Can anybody tell me if this is legal in the UK? Mains gas is much cheaper than electricity per kwh and the fact I've never heard of anybody doing the same...
Hi All
After having pooling water on my drive, I dug down around to find:
Black pipe poly/plastic dug 450mm deep spraying water at mains pressure from small hole/crack
The outside of pipe (measured with veneer caliper) at 23.5mm
Pipe Runs under drive, along side of property and looks to go...
Hi I have a question, I want my flat to be separately connected to the mains water supply for water coming into my kitchen and bathroom instead of sharing the same pipework as my neighbours. Is this doable and if so is it the water board who will carry this out or a plumber?
My flat has shared...
I currently have an 8.5kw electric shower on a gravity fed system in bathroom which doesn't give great flow when hot turned up but to get a 10mm cable to fuse board would be really difficult at best (I've checked and on 6mm at the minute)
I would like a mains shower however changing to unvented...
Background
I have a small one-bedroom flat in the roof space in a victorian house. There are three floors below and each floor has a single one-bedroom flat. The mains pipe bringing water into my top-floor flat is 15mm copper pipe. There is a water meter in the flat and a stop valve.
There is...
Good morning
I installed a Harvey’s water softener recently. Have a semi detached property with 3 showers and a 2 toilets with a mega flow cylinder
25mm mains pipe work with 22mm onwards. I put the softener before the prv which was pre installed with the unvented cylinder as the rep said...
We have a vaillant combi boiler that over ~ 2yrs loses a bit of pressure, and recently after 2 weeks away and no use the system would not fire and errored with F75.
We attempted to refill, but the mains pressure is only 1.0bar, and the combi needs more than that to light.
I ended up removing...
I have a cold mains in that is a black flexible rubber looking pipe. Please see photo 1. It is currently connected to a 22mm stopcock.
I’d like to send it 90 deg to the right. This is so I can lower the shelf above it and have the mains come in at a more convenient place. See photo 2 (with...
Hi guys I'm wanting to install an electric shower in my new property what's the easiest way to check it bath tap is coming from mains ?
The mains stop tap is located near the toilet in the room underneath me, when I switch that off it shuts all cold water off for every tap in the house.
If I...
I need to get a 22mm mains to an unvented tank in my loft.
Is an old house and the first part of the roof is pitched and sloping from the inside. The easiest way to get it into the loft is straight up the wall internally and then into the sloping roof the other side of the plaster board.
This...
Last summer I used one of those kits to fit an external tap , all went well , still good , its one of those flexi pipe , self cutting tap jobs , doesnt leak , all seems good, However , I would like to increase the pressure , I know those self cutters only cut a very small hole in the copper...
Hi all, I've been researching and planning a job for my home the past few days and a few pieces of advice would be welcome to help me along the way.
I have a cloakroom toilet which has a toilet and a sink, where the sink currently is there is good room to put a small shower cubicle and a...
Hi all
Just had a new mains water pipe fitted and the hot water is very slow almost a trickle. We have a combi vaillant ecotec pro 824 and it seems to come out fast to begin with then slows down considerably. It seems the boiler is struggling to provide hot water at the adequate rate that it...
Sure, ad-blocking software does a great job at blocking ads, but it also blocks useful features of our website. For the best site experience please disable your AdBlocker.