Search the forum,

Discuss General rant thread in the Plumbing Jobs | The Job-board area at PlumbersForums.net

Status
Not open for further replies.
Is the boiler a bit too the left of the flue hole ?? dunno i give up.
 
Do brick work from face side! Any way who said owt about bricking up? 300mm from flue.
I went to a logic on Monday lazy gits couldn't even be bothered to brick up the balanced flue hole so the put 30mm MDF board on the wall and mounted the boiler on that ffs.
 
Was working from a schedule of rates for a ha and they wanted me to supply and fit a circulating pump for 49 quid. The job was also 39 miles away.
Told them to ball lix
 
New posts
Status
Not open for further replies.

Reply to General rant thread in the Plumbing Jobs | The Job-board area at PlumbersForums.net

Similar plumbing topics

    • Like
Hi I'm saying hello so I can keep my account live. I'm more of a reader than a poster. As a beginner/ complete novice, I just need to find general answers to questions I may have. Generally I only replace existing plumbing and use plumbing skills to plumb my being equipment together.
Replies
2
Views
186
Hi all, Desperately in need of help. Getting very annoyed with myself Replaced the click plug in my bathroom for a new Basin Slotted one along with the Thomas Dudley Basin Waste kit All relatively straightforward to put together but why is it still dripping I'm using the preexisting metal...
Replies
5
Views
364
  • Sticky
I thought I'd create a master thread to move all of these similar threads into, over time like. If your central heating doesn't work boiler doesn't work radiators not working radiators or heating system is cold thermostat wont work or respond Then post a reply in this thread. Rather than us...
Replies
8
Views
1K
I am fitting a thermostatic shower control. The flow knob fitting has a threaded section - 27mm OD - and it would be helpful to get a nut to go on it. Can anyone advise what I need and where to get it please?
Replies
13
Views
550
In short: Do suppliers sometimes list BSPT as BSP? I need a tee, 22mm each end with a BSPT in the middle for an expansion vessel to dangle from. Why I think its I've used calipers on the threads and counted them, and the male end sticking out of the vessel is BSPT 3/4 with 14 threads per inch...
Replies
2
Views
360
Creating content since 2001. Untold Media.

Newest Plumbing Threads

Back
Top
AdBlock Detected

We get it, advertisements are annoying!

Sure, ad-blocking software does a great job at blocking ads, but it also blocks useful features of our website. For the best site experience please disable your AdBlocker.

I've Disabled AdBlock