- Messages
- 5,439
Non-flushing loo. Tried it myself, standard syphon diaphragm change - handle returned to original position after pulling.
After changing diaphragm (was 3 part detatchable syphon, so original syphon remained after changing diaphragm) everything worked fine but handle won't pop up again after flushing. Have had this when installing new handles with syphons before, usually got it by changing linkage size, arm hole used etc.. But I hadn't changed anything. Never undid handle. Only two holes available on arm, tried both.
Is it caused by not enough tension in linkage and arm to pull it back? Or maybe too much? Or something else? I tried adjusting it quite a few times but problem remained.
Not the most dramatic problem but quite annoying.
After changing diaphragm (was 3 part detatchable syphon, so original syphon remained after changing diaphragm) everything worked fine but handle won't pop up again after flushing. Have had this when installing new handles with syphons before, usually got it by changing linkage size, arm hole used etc.. But I hadn't changed anything. Never undid handle. Only two holes available on arm, tried both.
Is it caused by not enough tension in linkage and arm to pull it back? Or maybe too much? Or something else? I tried adjusting it quite a few times but problem remained.
Not the most dramatic problem but quite annoying.