Discuss Variable flow Water Pump for instant water heater? in the Plumbing Jobs | The Job-board area at PlumbersForums.net

Status
Not open for further replies.
The instant heater normally place within 2M from the shower head, as I place it in boiler room the hot water pump can restore the pressure lost when the water pass through the pipe.
 
The instant heater normally place within 2M from the shower head, as I place it in boiler room the hot water pump can restore the pressure lost when the water pass through the pipe.

No problem
Ill see you when your back asking how do I get the water hotter after I have added a pump to system
Look forward to reading it
Now I'm out lol
 
using your maths you are going to shower with 60degree hot water if you have an unvented cylinder? if so then your maths is correct but the third person wont be able to have a shower, they will be too busy taking the first two people to the burns ward of the local hospital.

chrispy duck LOL

or should i say chrispy duckyUC
 
Last edited:
And as for differences of opinion......

Only really works when both parties know what they're talking about.
 
The pulsa coil boiler do have an internal hot water pump to increase the pressure too, I cant see the why install a hot water pump will cause problem for the instant heater.
Since the pump can tune the output, I can get the increase pressure at the level I need without temp drop too much.

If you say no to the set up, please give a physical reason to it. Otherwise that will become the fight of religion again.
 
The pulsa coil boiler do have an internal hot water pump to increase the pressure too, I cant see the why install a hot water pump will cause problem for the instant heater.
Since the pump can tune the output, I can get the increase pressure at the level I need without temp drop too much.

If you say no to the set up, please give a physical reason to it. Otherwise that will become the fight of religion again.

What are you on
 
Gray0689:

For your problem , that is why I need a pump can tune the output to stop excess cold water flow.
Even In the worst case the pump wont make difference, but if the plan work then the whole system are way better than the storage idea.
 
Last edited by a moderator:
Status
Not open for further replies.

Reply to Variable flow Water Pump for instant water heater? in the Plumbing Jobs | The Job-board area at PlumbersForums.net

Similar plumbing topics

  • Question
Ideal Logic 24, Previous problem was that the hot water was only cold or barely warm if the heating was in use. If heating was off and boiler cold...
Replies
2
Views
227
I have an ideal vogue max S18 boiler and I’m considering fitting auto balancing TRVs, my question relates to the boilers pump. I see a boiler...
Replies
1
Views
196
Hello plumbers in my internet. So the Mrs want a spray mixer tap in the kitchen as we had two separate taps. I changed the tap for a temporary two...
Replies
2
Views
227
Hi, I have a Worcester 28i junior boiler that has started to lose pressure, only when using the central heating. When using hot water I have no...
Replies
6
Views
277
Hi, Can anyone advise as to why the cold water to my bathroom keeps airlocking? This originally happened about 12 months ago and has happened 3-4...
Replies
9
Views
465
Back
Top
AdBlock Detected

We get it, advertisements are annoying!

Sure, ad-blocking software does a great job at blocking ads, but it also blocks useful features of our website. For the best site experience please disable your AdBlocker.

I've Disabled AdBlock