Search the forum,

Discuss Vaillant flow restrictor in the Plumbing Jobs | The Job-board area at PlumbersForums.net

Scott_D

Esteemed
Plumber
Gas Engineer
Subscribed
Messages
6,131
Anyone else had complaints of poor hot flow on Vaillant combis?
They are restricted to the lpm that allows the boiler to give a 42 degree rise
24kw 8lpm
30kw 10lpm
It means the water is hot but the flow “isn’t as good as the old boiler”
 
Anyone else had complaints of poor hot flow on Vaillant combis?
They are restricted to the lpm that allows the boiler to give a 42 degree rise
24kw 8lpm
30kw 10lpm
It means the water is hot but the flow “isn’t as good as the old boiler”
This is why you end up fitting an 835 in place of an 30 kw old boiler in a 3 bed. As the old boiler probably did 13lpm and a 30 kw Vaillant will not do that. So you have to fit the 835 and range rate the heating.
 
This is why you end up fitting an 835 in place of an 30 kw old boiler in a 3 bed. As the old boiler probably did 13lpm and a 30 kw Vaillant will not do that. So you have to fit the 835 and range rate the heating.
It means the boiler costs more and needs a gas upgrade
It’s a shame you can’t remove the restrictor and fit one that allows a 35 degree rise
 
It means the boiler costs more and needs a gas upgrade
It’s a shame you can’t remove the restrictor and fit one that allows a 35 degree rise
That’s why it is important to check flow rates when upgrading boilers and not just banging in a direct replacement. Vaillant have a 15mm connection on the gas. I have only ever had to upgrade about 5 gas pipes in my time.
 
Most boilers have restrictions stops too much flow going through the plate and giving warm water

Baxi in the tails
Worcester in the plate/ pipes to the plate
Vaillant in the iso valves
Etc
 
Most boilers have restrictions stops too much flow going through the plate and giving warm water

Baxi in the tails
Worcester in the plate/ pipes to the plate
Vaillant in the iso valves
Etc
Restricting to allow a 35degree rise is understandable.
 
Restricting to allow a 35degree rise is understandable.

42 most are now starting to do especially on the lower kw as winter time there not getting as hot eg 35 degrees etc
 

Reply to Vaillant flow restrictor in the Plumbing Jobs | The Job-board area at PlumbersForums.net

Similar plumbing topics

  • Question
Ideal Logic 24, Previous problem was that the hot water was only cold or barely warm if the heating was in use. If heating was off and boiler cold then would get hot water most of the time. Changing the flow cartridge about 2 years ago (when I moved in) solved this problem enough to suffer it as...
Replies
2
Views
172
Recently had a Viessmann Vitodens combi boiler installed, quite often when the adjacent cold mixer tap is opened the boiler starts for a few seconds! Can anyone tell me what is causing this? And how to cure?
Replies
3
Views
224
Every two weeks or so I have to go and top up the system because the hot taps are running cold. Boiler display is flashing 0.6 bar and I fill up to 1.3. I've had an engineer look inside the boiler and he can't see anything wrong. I've checked the pipes all over the house and cannot see any...
Replies
2
Views
246
P
Hello plumbers in my internet. So the Mrs want a spray mixer tap in the kitchen as we had two separate taps. I changed the tap for a temporary two hole mixer but the cold water pressure is high mains fed and the hot is low pressure immersion tank fed. I've been trying to find info on what I...
Replies
2
Views
176
Hello, I am seeking some advice, I have a POTTERTON PROMAX 28 COMBI Boiler and I noticed yesterday that the water around the house is no longer warming up. The heat exchanger has been changed 6 months ago, so I do not believe it is that. Does anyone have any ideas on what it could be? Thanks
Replies
4
Views
275
Creating content since 2001. Untold Media.

Newest Plumbing Threads

Back
Top
AdBlock Detected

We get it, advertisements are annoying!

Sure, ad-blocking software does a great job at blocking ads, but it also blocks useful features of our website. For the best site experience please disable your AdBlocker.

I've Disabled AdBlock