Search the forum,

Discuss To all Grant installers in the Plumbing Jobs | The Job-board area at PlumbersForums.net

Status
Not open for further replies.
If I ever use 10mm compression fittings (which is once in a blue moon) I always use inserts.

I have a litre pot of Heldite and I use it to top up a small pot which I keep in the toolkit.
 
I have asked before and not had any. Just done a search on the trade store as well. No heldite there. Going to order quarter of a litre from the link Croppie posted.
 
If you get stuck without Heldite, Halfrauds sell little tubes of Hermetite Red which works too and is approved for oil.
Expensive for what it is but can get you out a hole when the pot of sealant has disapeared off the van somewhere,
 
Status
Not open for further replies.

Reply to To all Grant installers in the Plumbing Jobs | The Job-board area at PlumbersForums.net

Similar plumbing topics

I was stupid enough not to check the position of the pipes under the tiles when installing a toilet and drilled right through the center of a 16...
Replies
0
Views
221
Hello all, I'm would like to extend an existing outside tap to another point in the garden. I'm about to pour a concrete patio and was hoping to...
Replies
6
Views
264
Hello all, I’m replacing a concrete paving slab patio in the back yard. The original patio used 50mm deep concrete slabs on hardcore & sand. I’m...
Replies
6
Views
295
Creating content since 2001. Untold Media.

Newest Plumbing Threads

Back
Top
AdBlock Detected

We get it, advertisements are annoying!

Sure, ad-blocking software does a great job at blocking ads, but it also blocks useful features of our website. For the best site experience please disable your AdBlocker.

I've Disabled AdBlock