got a few domestic jobs on now to do after work , not being on site until 5:30pm and leaving 10pm ish I don't get much done in an evening , one is a holiday apartment that needs the ch re piping and the hot + cold , new bathroom ect , its not a big job , but then you only have 4ish hours there every evening its not going to move on as fast as I would like it to , the walls are being battened out, and I need to clip pipes onto the brick behind with nail ins . I only ever use copper , but most other guys around here are plastic more and more , so im thinking why not join them , I suppose id be quicker aswell . but I don't trust push fit, has anybody tried the press fittings? im seriously thinking of going down that route, but the cost is putting me right off, does anybody buy them and use them ? how much for example is a 15mm elbow? are they less bulky than push fit? would I be better off using tectite push fit? can I crimp a plastic pipe one end of an elbow and copper the other to come up to rads ? I know if I start I copper ill be there for weeks , and summer approaching and a licensed fishing boat sitting in the shed ...... ive got better things to do after work than soldering !!!!