Search the forum,

plumber down under, or will be soon

Post new thread

Discuss plumber down under, or will be soon in the Plumbing Jobs | The Job-board area at PlumbersForums.net

Status
Not open for further replies.
F

flat pack

moz-screenshot.jpg
moz-screenshot-1.jpg
something to put in your photo album





http://renomart.com.au/wp-content/uploads/2007/03/dodgy-plumbing.jpg
 
Status
Not open for further replies.

Reply to plumber down under, or will be soon in the Plumbing Jobs | The Job-board area at PlumbersForums.net

Similar plumbing topics

D
UK Can't get stopcock 100% closed to allow a tap repair
I have a plumber coming tomorrow to change a cartridge on a badly dripping tap on my bathroom mixer unit. There is no separate isolating valve for this tap so I'll have to close the stopcock. I tried closing it today but it won't go absolutely 100% closed and there is still a very slight flow...
Replies
1
Views
275
Chuck
C
dreikher
Hole in copper pipe, solder under floor, T coupling & protection
I was stupid enough not to check the position of the pipes under the tiles when installing a toilet and drilled right through the center of a 16 mm copper water pipe. I exposed the pipe by removing a ~30cm section of the plastic sleeve and a ~10 cm section of the pipe around the hole. Several...
Replies
0
Views
220
dreikher
dreikher
C
How to identify dripping tap.
Our kitchen mixer tap has started dripping. Like so much of the plumbing in our almost new build bungalow, it is lacking! The plumber didn't install any isolating cocks in the H&C feed to the tap so how can I identify which of the valves is passing? Shut the whole H&C water system down?
Replies
12
Views
398
Timmy D
T
A
copper vs pushfit pipes
Copper pipes, I think its fair to say, is not what it used to be, the copper is getting thin while the cost is going up. Meanwhile, plastic Pushfit seems to be getting better and better, cost and convenience was always better, but now the quality is to, have we reached a stage where plastic will...
Replies
2
Views
285
Chuck
C
127bit
How to reinforce shower pan threshold?
The left rear floor corner is highest (the shower pan touches/sits on the floor), sloping down diagonally to the front right corner (lowest). The front right corner shim is 5/8", the left front corner is 3/8" shimmed, with shorter shims under left middle and right rear corner. The pan perimeters...
Replies
6
Views
233
127bit
127bit
Creating content since 2001. Untold Media.

Newest Plumbing Threads

Tiling Blog
UK Tiling Forum
Tiling Tools
Tile Advice
UK Tiling Forum
Back
Top
AdBlock Detected

We get it, advertisements are annoying!

Sure, ad-blocking software does a great job at blocking ads, but it also blocks useful features of our website. For the best site experience please disable your AdBlocker.

I've Disabled AdBlock