Search the forum,

Discuss Part cold rad...no bleed valve!!! in the Plumbing Jobs | The Job-board area at PlumbersForums.net

Status
Not open for further replies.
N

NDUD1

Hi

I have got a part cold radiator upstairs that does not have a bleed valve. I have tried bleeding the other rads but only water comes out. can I fit a drain cock to this rad to try and expel the air that way or is it better to buy a new rad with a bleed valve. it is the only rad in the house without a bleed valve and all other rads and water are working fine

thanks :confused:
 
Not sure what you mean. Many rads have two 1/2" bsp top tappings and two bottom ones the same.

If you have two plugs in the top tappings, all you need do is take one out and replace it with an air bleed plug.

Hope this helps.
 
hi. it is a single radiator and does not have any tappings that can be knocked out. the only entry and exit points are for the water flow. im thinking the rad may be off an older sealed system that didnt require bleeding....does this help?????

thanks
 
Have a look at the rear of the radiator at the top. There should be a bleed point in one of the corners.
 
sorry...i know it sounds ridiculous....but there is no bleed point on the rad...not sure how old it is...it must be unique if no one has seen one without a bleed point...thats why im struggling!!!....i thought of fitting a drain cock on it but as it is an upstairs rad would this be wise??...

thanks again

well after mooching around at the back of the rad in the left hand corner....guess what Ive finally found .......the bleed valve..... hiding...at last its hot

thanks folks...i knew i could rely on your experience....
 
Last edited by a moderator:
Never seen a rad without a bleed valve, older rads had the bleed valve on the REAR of the radiator on the top left or right.
 
as mushybees says it sounds like a round top rad and the bleed valve should be to the right hand side of the rad but actually behind the rad facing the wall.
regards
Mike
 
Last edited:
I recently bled a radiator that's bleed valve was behind it, covered by a small plastic piece.
 
Get a make up mirror or a dentists mirror , i have used this before when it was round the back and too tight to the wall.
 
Status
Not open for further replies.

Reply to Part cold rad...no bleed valve!!! in the Plumbing Jobs | The Job-board area at PlumbersForums.net

Similar plumbing topics

I have had a look at previous posts and think I know the answer to this but just before I make it worse could I just check what you think about this one. Granddaughter just moved house and this valve decided to leak when it was closed. When open its fine. Normally I have repacked the gland on...
Replies
7
Views
210
Hi, Can anyone advise as to why the cold water to my bathroom keeps airlocking? This originally happened about 12 months ago and has happened 3-4 times since. It’s an upstairs bathroom, fed from a tank in the attic. The tank is about 8 Meters away and feeds a bath, sink and toilet. The tank...
Replies
9
Views
365
Hi all I'm hoping someone can shine a light on this for me Since our stop tap on the pavement has now been filled with sand for whatever reason, we are relying on our property fitted stopcock (this is outside on our garage wall) Unfortunately turning this to the closed position only reduces...
Replies
3
Views
283
Creating content since 2001. Untold Media.

Newest Plumbing Threads

Back
Top
AdBlock Detected

We get it, advertisements are annoying!

Sure, ad-blocking software does a great job at blocking ads, but it also blocks useful features of our website. For the best site experience please disable your AdBlocker.

I've Disabled AdBlock