non return valve

[starbs]

Morning all I fitted an en-suite in a loft conversion a month of so ago and the customer has just started to use it now works completed in the rest of the conversion. They have contacted me to say they have a bit of an issue when they use the hand basin cold tap as in they get a nice pocket or (cough) of air delivered out the tap before any water is drawn off, would I be right in saying a non return valve will cure this? All the other taps are ok so ive been informed (both bath taps) and hot on basin. I did think about putting the NRV on the cold supply pipe upto the loft or would it be better placed near the basin tap?

thoughts please cheers in advance

 

[T & H Plumbing]

Once water is drawn thru the taps the air will disappear its due to new pipework tell your customer to run the taps for a few minutes it should clear the air

And to be honest you should have done this before handing it over

 

[starbs]

cheers for your comment I did run the tap for a while and it did cough out the initially and clear but its been reported to me that its a continual issue every time they turn on the tap, hense me asking if fitting a NRV will stop the water in the system draining back down as this is what I believe may be
happening

 

[T & H Plumbing]

I may be wrong but if you have air locks there could be a leak somewhere

Is the pressure on bolier holding?

 

[kris]

What kind of hot water system is it ,,, i presume its gravity going by symptoms , if its gravity it might be WHERE youve drawn the hot connection at thats causing this especially if your too high where head of pressure is low and they draw off water downstairs is when this can occur,

 

[kris]

What kind of hot water system is it ,,, i presume its gravity going by symptoms , if its gravity it might be WHERE youve drawn the hot connection at thats causing this especially if your too high where head of pressure is low and they draw off water downstairs is when this can occur,

Soz read your thread wrong thought u said hot tap MY BAD I NEED TO GO TO



SAVERS

 

[kris]

Whats the cold main pressure like as unusual for this mains, mind u our mains can be as high as 10bar just outside town,

 

[T & H Plumbing]

Thing is Kris he's asking is a check valve will sort the air gaps and it won't will it????

 

[SimonG]

Pressure on boiler has sfa to do with the taps.

 

[kris]

I may be wrong but if you have air locks there could be a leak somewhere

Is the pressure on bolier holding?

I know andy remember the boiler pressure if its a combi has nothing to do with cold apart from filling ,
It depends if his tap is spitting air or suckin air for a start, you said a leak but even with a leak there would always be pressure behind the supply not allowing the level in the pipework to drop, unless :smile5: poor pressure, thats why i wonder if its mains or tank fed, or an aerated spout gone mental,,,,