M10 stud cut to length

[Nostrum]

Does anyone know where you can buy pre cut M10 stud (40,60,80mm ish) ?

Do Geberit do a stud cutter attachment for press tools, I know REMS do?

killing grinder blades and not ending up with a very clean cut!

 

[Nostrum]

jesus, no one use a mini hacksaw now a days

Alright gammy hand, jump back in your orange bath tub.

I've got better things to be doing then spend half a day cutting threaded bar with a junior hacksaw. :25:

 

[gasmanrob]

No!

This is why you're falling apart ate it's not old age it's just doing things the old way that's doing ot

 

[gasmanrob]

Is that on there now? I've seen them second hand for more than they are new!

No that's one I won a few months back

 

[lame plumber]

the other option is the apprentice.......

 

[Nostrum]

I'm pretty sure that dodgy wrists the cause of his misses cold shoulder, not a junior hacksaw.

 

[lame plumber]

I'm pretty sure that dodgy wrists the cause of his misses cold shoulder, not a junior hacksaw.

naw it's the green slime running out my nostrils

 

[rpm]

Does anyone know where you can buy pre cut M10 stud (40,60,80mm ish) ?

As there are plumbers merchants there`s the same for engineers. :53:

 

[Nostrum]

As there are plumbers merchants there`s the same for engineers. :53:

Eh? :deal:

 

[lame plumber]

As there are plumbers merchants there`s the same for engineers. :53:

double Eh

 

[rpm]

Good shout but it's still easier buying it pre cut!

OK, it`s your money.

 

[lame plumber]

any way. its only an orange bath tub if things have gone rather badly and its upside down

 

[rpm]

Merchants for engineers will have single lengths & pre cut.

 

[lame plumber]

or you could just use a chop saw..................

 

[hammers4spanner]

small hacksaw cutting threaded lol

 

[tolly]

BSS do precut m10 stud in loads of different lengths the smaller sizes go up in 10mm increments