Discuss Hot water tank in a flat has poor flow rate after refurbishment. in the DIY Plumbing Forum area at PlumbersForums.net

Messages
8
Good morning everyone. My parent had a new kitchen and bathroom fitted in her flat 2 years ago and has only now told me that the hot water flow to both hot taps is really poor. it wasn't like this before. its a flat with a 1075x450 IND BS combi HW tank. she says that the tank was drained down during the works. MY question is, can i desludge or clear the blockage or do i need a new tank?
 

Reply to Hot water tank in a flat has poor flow rate after refurbishment. in the DIY Plumbing Forum area at PlumbersForums.net

Similar plumbing topics

Background I have a small one-bedroom flat in the roof space in a victorian house. There are three floors below and each floor has a single...
Replies
3
Views
604
Looking for any ideas to help. I've a Heatrae Sadia Hot Water tank, heated through Oil fired boiler (working fine). A week ago I reset the air...
Replies
8
Views
350
Hello, I’ve been doing my first refurbishment is a two bed flat with a bathroom and ensuite . Learnt a lot and been grateful for input’s...
Replies
10
Views
892
First post as I can not figure this one out. I have a hot water boiler heating system, gas fired, with an HTP SuperStor indirect hot water tank...
Replies
2
Views
413
Hi, We have a large Heatrea Sadia unvented hot water tank, not sure of the size in liters but its about 1600mm tall. The tank is around 3 years...
Replies
0
Views
419
Back
Top
AdBlock Detected

We get it, advertisements are annoying!

Sure, ad-blocking software does a great job at blocking ads, but it also blocks useful features of our website. For the best site experience please disable your AdBlocker.

I've Disabled AdBlock