Discuss Holding a 3 port valve in the Plumbing Jobs | The Job-board area at PlumbersForums.net

Status
Not open for further replies.
X

xtremeo

Hi is it possible to hold a vaccum with bungs and change a 3 port valve, and it is 3 openings and I believe you can only have 2 openings, if not does anyone have any other solutions without draining down, or any other tips.
thanks
 
Hi pipeworks a nightmare possible airlocks, what's the the best freeze kit to buy.
 
Electric are best but only two freeze heads. Are there no isolation valves/pump valves nearby so you can just freeze the legs to the heating and hot water circuit? Hiring a machine is the best bet. I have done it on problematic systems with freeze spray but only in outbuildings with oil boilers where a bit of water is not too much of an issue. If you can isolate the flow to the 3 port valve you could try bunging it. I probably wouldn't try it in an airing cupboard though!
 
Can be done but not if you're not confident. Hire an electric freezer for the day. No stress no rush
 
Hi thanks for that what's your opinion on rothenberger co2 kit rofrost , lot cheaper than electric thanks
 
Hi thanks for that what's your opinion on rothenberger co2 kit rofrost , lot cheaper than electric thanks

the problem with the co2 kits is you need to work fast as once the gas runs out well you know the next bit

you can hire the electric ones for about ÂŁ50-80 a day
 
My thoughts on the CO2 kits take me back to the video I watched earlier with a fella in a flat flooding the place. With an electric kit you leave it on and have no worries. If you have a local Williams branch they hire them for about ÂŁ35 a day if I remember right
 
My thoughts on the CO2 kits take me back to the video I watched earlier with a fella in a flat flooding the place. With an electric kit you leave it on and have no worries. If you have a local Williams branch they hire them for about ÂŁ35 a day if I remember right
Trade only mate
 
Status
Not open for further replies.

Reply to Holding a 3 port valve in the Plumbing Jobs | The Job-board area at PlumbersForums.net

Similar plumbing topics

Hi everyone, Looking for a bit of advice, recently went to a job where heating was operating when called for however not for the hot water. I...
Replies
8
Views
393
I have had a look at previous posts and think I know the answer to this but just before I make it worse could I just check what you think about...
Replies
7
Views
256
Hi all. Hope you have all been keeping well. A while back I decided I only wanted to fit one brand of boiler and decided on Viessmann due to...
Replies
9
Views
320
Hi, Can anyone advise as to why the cold water to my bathroom keeps airlocking? This originally happened about 12 months ago and has happened 3-4...
Replies
9
Views
441
Hello, I am seeking some advice, I have a POTTERTON PROMAX 28 COMBI Boiler and I noticed yesterday that the water around the house is no longer...
Replies
4
Views
288

Newest Plumbing Threads

Back
Top
AdBlock Detected

We get it, advertisements are annoying!

Sure, ad-blocking software does a great job at blocking ads, but it also blocks useful features of our website. For the best site experience please disable your AdBlocker.

I've Disabled AdBlock