Hints, tips & secrets of plumbing - No Banter please!

[Whyme]

keep a few pushfit stop ends in ur pockets for code red (brain dead) situations.

 

[chris watkins]

Brass 3" 12's do me Chris. I certainly wouldn't use a frame fix.

Yes, sorry but the floors are not so good down here as the granite you may be use too Tamz
(PS you are right it was 3 not 4 oh how old age effects the memory that & the bottle of wine, well it has been a good day, sun shining Alpha solar kit installed & the BL-----dy kids not back until Monday, O a few more days of bliss)

 

[Mike Jackson]

Brass 3" 12's do me Chris. I certainly wouldn't use a frame fix.

I struggle to find brass screws now. I've started using stainless steel.

 

[GQuigley67]

if ever doing a combi to combi swap, have a wee peak up in the loft you never know some one might have left you a little present i.e hot water cylinder or some scrap pipe at least:christmaswreath:

 

[Ermintrude]

Strip foam cylinder by cutting it from top to bottom so it's segmented, do this in 3 or 4 places. Once around circumference mid way up cylinder. Cut as deep as u can through foam. Lay on its side and stamp on it once or twice. Insulation comes off in about 8 bits not 20000.

Tip two buy recip saw and u will never leave any loot behind in an attic or tight space again.

 

[Mike Jackson]

Easier to cap off cold feed and put wet vac on outlet. Cylinder will implode and the insulation will fall off.

 

[woodytheplumber]

when fitting rads under a window sill measure down from the sill for top of bracket height fix brackets pop rad in place check levels and whichever side is the high spot pop the bleed valve on . I go to quite a few complaints (not my jobs) that are rads that seem un level when infact its spot on but they look out because of the sills

 

[Kyle87]

when fitting rads under a window sill measure down from the sill for top of bracket height fix brackets pop rad in place check levels and whichever side is the high spot pop the bleed valve on . I go to quite a few complaints (not my jobs) that are rads that seem un level when infact its spot on but they look out because of the sills

I'd speak to customer first. "Do you want rad level or parallel to windowsill?"

With some people no matter what you do they will find a problem.

 

[woodytheplumber]

fair play I just do it as a standard only ever had one customer follow me round with a level and they didn't find one level rad of mine all the ones under the window sill were perfectly parallel and every other rad I fit I send a level line across fit brackets check for level and if they are spot on I send a tiny tap to one of the brackets I was always taught to have a slight un level on rads up to the bleed nipple and as I think its make perfect cense that's how I fit them ime not talking much but over sat a 1200 level 2 milly is in my eyes perfect

 

[Neil T]

note to self: when reconnecting appliances in property where council have been in and decommisioned it, check EVERY connection on every appliance including supply! numbnuts had loosened the supply to the meter put new olive in and just turned nut slightly ... i got wet