Help on various fittings needed!

[chrisab]

Hi,


I'm trying to get a list together for screwfix, can anyone offer any light into the following questions?

Image 948 - this is the bottom of a riser rail with integral supply to the rose. Water in connects to the brass fixing - any ideas what fitting you need to go onto it and how it secures to the wall?! No instructions...

949-950 - thermostatic diverter valve. Is that just going to be 1" bsp? I want to go to 22mm plastic pipe so I need 1" to 22mm push in or 1" to 22mm compression?

951- flexi pipe for sink taps. Is that likely to be 1/2", It needs to go onto 15mm pipe but I can't find any 1/2" to 15mm fittings?


Oh and is it worth spending a bit extra for speedfit rather than flo-fit? Do both work with any plastic or copper pipes (with inserts)?

Thanks

 

[Simon F]

951- flexi 1/2" x 15mm
http://www.*************/p/flexible-tap-connector-15mm-x-x-300mm/13143





ps:- fill in the blanks

 

[dancinplumba]

even a beginner plumber should know all this
imho

 

[chrisab]

thanks simon, I'm planning on putting a 15mm isolator using compression fitting onto inlet pipe and take off the olive/nut on the other end and screw the flexi hose straight onto the isolator. Hope that works.

Going to get a wall mounted 1/2 elbow for the riser rail integrated supply.

For the diverter valve, would these work (screwfix item 34980) -FloPlast Flo-Fit Tap Connector 22mm x ¾" for the hot and cold inlet. Then need to find similar but with male 3/4" ends on for the two outlets.

Cheers