Search the forum,

Glow worm bypass seals

Post new thread

Discuss Glow worm bypass seals in the Plumbing Jobs | The Job-board area at PlumbersForums.net

M

mutley racers

Esteemed
Plumber
Gas Engineer
Subscribed
Messages
5,172
Hi folks, anyone know what seals I need for the boiler below. Cannot find out if it is just the o'rings or seals as well.

Cheers

20181115_133619.jpg


20181115_133531.jpg
 
Cant say for definite on this model, but the divertor valve / bypass normally on the valiants/glowworms have two slightly square(flat one side) shaped o-ring seals cant help you with part number though just been to the van i have one in there but no part numbers on the exploded diagram.... useful.
 
cmarkr said:
Cant say for definite on this model, but the divertor valve / bypass normally on the valiants/glowworms have two slightly square(flat one side) shaped o-ring seals cant help you with part number though just been to the van i have one in there but no part numbers on the exploded diagram.. useful.
Click to expand...


Thanks. Turns out in the end all it needed was to be tightened up a tad more. Well, no call backs as of yet any way
 

Reply to Glow worm bypass seals in the Plumbing Jobs | The Job-board area at PlumbersForums.net

Similar plumbing topics

P
LCS to new water mains
Hi, I have an old steel water mains pipe (approx 45mm) that I need to connect to a new pehd water mains (25mm). I can't get at it to create a new thread so what's the best way of connecting the two? Cheers, Peter
Replies
2
Views
196
ShaunCorbs
ShaunCorbs
dreikher
Hole in copper pipe, solder under floor, T coupling & protection
I was stupid enough not to check the position of the pipes under the tiles when installing a toilet and drilled right through the center of a 16 mm copper water pipe. I exposed the pipe by removing a ~30cm section of the plastic sleeve and a ~10 cm section of the pipe around the hole. Several...
Replies
0
Views
190
dreikher
dreikher
P
Viessmann combi starts when cold, mixer, tap is opened
Recently had a Viessmann Vitodens combi boiler installed, quite often when the adjacent cold mixer tap is opened the boiler starts for a few seconds! Can anyone tell me what is causing this? And how to cure?
Replies
3
Views
205
ShaunCorbs
ShaunCorbs
Stigster
Does anyone know the name of this model of Roca toilet?
Hi guys. I'm trying to identify a toilet model before ordering a seat for a customer. I went to what used to be a Roca stockist (they no longer are) and one of the guys there reckoned it might be "The Gap". I went to the new stockist and the guy there disagreed it was "The Gap" and that he'd...
Replies
2
Views
140
Stigster
Stigster
B
What is correct toilet supply line
Hi. I need a new toilet supply line but don’t know the size type of the fitting at the shut off valve. It is not 3/8 compression. It is a plastic nut about the same size as the one going into the cistern but has a different thread. Attached is a photo. Can you advise. Thanks.
Replies
2
Views
189
ShaunCorbs
ShaunCorbs
Creating content since 2001. Untold Media.

Newest Plumbing Threads

Electricians' Talk
Plumbers Forum - Plumbing Advice
BS 5389 Tiling Standards
Electricians Talk
Tile Blog
Back
Top
AdBlock Detected

We get it, advertisements are annoying!

Sure, ad-blocking software does a great job at blocking ads, but it also blocks useful features of our website. For the best site experience please disable your AdBlocker.

I've Disabled AdBlock