Discuss Combi boiler Size in the Plumbing Jobs | The Job-board area at PlumbersForums.net

Status
Not open for further replies.
T

th3pony

Hi I'm doing up my house and I'm looking for a combi boiler, the space i want it to go in will only allow for a boiler 630mm in height if this is possible. Also I would like to know, do I need to leave 200mm clearance top and bottom. Thank you.
 
find one online or at merchants and follow mfis when your installer fits it re clearances. do not try to fit in to smaller place as your installer/service engineer needs to be able to access pipework etc
 
i have been looking but i'm struggling to find one at 630mm or smaller
 
yes that could be a possibility. Is it essential to leave 200mm at the bottom of the boiler, the kitchen worktop will be above it ?
 
your aiming to put a wall mounted boiler under the worktop! have a thought for anyone trying to work on it later, fraid I wouldnt its bad enough when I have to stand
 
No sorry the worktop is below the boiler think that came out wrong, what i meant to ask, do i need a 200mm gap between the bottom of the boiler and the worktop
 
its what the manufacturer says and common sense as well, remember someone has to work on the boiler annually, if youve no space then its hard and you bill will increase due to time taken etc
 
ok thanks, i have found one to fit on ebay its a lambourghini condensing combi, you know much about these ?
 
its italian, like the cars and they break down all the time so Id expect the same.
 
It is a rebadged ferroli i think and is possibly one of the worst boilers ever made.....

Look at ideal logic or if really desperate a 28i junior
 
one of the smallest is the Vokera vision with direct rear flue option but think this is 700mm and yes you do need to leave the required distance stated by the manafactuers
 
What about the Ideal Imini? I'v fitted these in a kitchen cupboard before & they are a very good boiler
 
have just discovered rear flue boilers online which now gives me a bit of extra space as i will not lose space at the top for the flue.
 
Status
Not open for further replies.

Reply to Combi boiler Size in the Plumbing Jobs | The Job-board area at PlumbersForums.net

Similar plumbing topics

Hello, bit of a noob question but would someone be able to help me to understand the pipes coming off our boiler. It's a Grant oil combi boiler...
Replies
9
Views
711
I'm in a bit of a bind with a current CH install where I need to install a filter prior to a flush but no where to install My issue is the...
Replies
7
Views
607
Hi everyone, Just a query about what size in KW gas combi boiler do I need for a top floor flat (3rd floor). I have a Vokera Easi heat plus...
Replies
16
Views
1K
D
I'm looking for a heating engineers/old school plumber to put in a Combi boiler (possibly Intergas) replacing very old open vent system in...
Replies
2
Views
1K
I
  • Question
Hi, just a quick question. Do I need to fill my combi boiler to run it for hot tap water only? I'm planning to drain the system and leave it...
Replies
1
Views
525
Deleted member 120897
D
Back
Top
AdBlock Detected

We get it, advertisements are annoying!

Sure, ad-blocking software does a great job at blocking ads, but it also blocks useful features of our website. For the best site experience please disable your AdBlocker.

I've Disabled AdBlock