Search the forum,

Discuss Card payments in the Plumbing Jobs | The Job-board area at PlumbersForums.net

Status
Not open for further replies.

helpsy

Plumbers Arms member
Plumber
Gas Engineer
Messages
1,754
I know there is a sponsor on here for card machines.....but I was wondering how many people have them?
 
I have one ( handy pay) . Most people like to pay through bank transfer though. Going to give mine back as its not used often enough.
 
I looked in to the Paypal one as dont take cards to often all direct transfer now. But I have signed up wuth pay pal and when customer can only pay by crefit or debit I can email them a pay pal payment requedt from my phone and they just folow the link in the email anter there card details and job done.
 
I looked in to the Paypal one as dont take cards to often all direct transfer now. But I have signed up wuth pay pal and when customer can only pay by crefit or debit I can email them a pay pal payment requedt from my phone and they just folow the link in the email anter there card details and job done.

Dam touch screen phone keys too close together apologies for wonky spolling.
 
and how long will it be before the Banks start charging for Bacs payments you think they cant cos its electronic transfer and there not involved you just wait and see!!!
 
and how long will it be before the Banks start charging for Bacs payments you think they cant cos its electronic transfer and there not involved you just wait and see!!!

Good question. I pay to put cash across a counter in to the company account. They cant even get that right. Paid in ÂŁ1500 in cash and a cheque on same paying in slip. All seemed ok untill I checked my statements. They credited ÂŁ1300 then ÂŁ1420 then ÂŁ1250 then ÂŁ1420 again then they deducted all but one of the ÂŁ1420 credits leaving my account down on what I had actually paid in by ÂŁ80. I then had to call them up to get it rectified which actually whent quite smoothly. Just cant believe I pay them for a service they cant even get right.
 
Status
Not open for further replies.

Reply to Card payments in the Plumbing Jobs | The Job-board area at PlumbersForums.net

Similar plumbing topics

Hello plumbers in my internet. So the Mrs want a spray mixer tap in the kitchen as we had two separate taps. I changed the tap for a temporary two hole mixer but the cold water pressure is high mains fed and the hot is low pressure immersion tank fed. I've been trying to find info on what I...
Replies
2
Views
136
Hi all Noticed bad smell in my drain out side put my hand down and it unclogged it for now however I checked my sewer drain and after flushing my toilet a good few times nothing is going to the sewer so don't know is there a blockage or what way it works many thanks and advice would be grateful
Replies
3
Views
520
Hi all I'm hoping someone can shine a light on this for me Since our stop tap on the pavement has now been filled with sand for whatever reason, we are relying on our property fitted stopcock (this is outside on our garage wall) Unfortunately turning this to the closed position only reduces...
Replies
3
Views
252
Just started gound work on self build bungalow and wondering best way to do below ground soil pipes. For toilet I was going to go straight down through slab and out through deadwork into a manhole. I will work out falls from manhole and set the height of the waste water system as required. For...
Replies
2
Views
114
The left rear floor corner is highest (the shower pan touches/sits on the floor), sloping down diagonally to the front right corner (lowest). The front right corner shim is 5/8", the left front corner is 3/8" shimmed, with shorter shims under left middle and right rear corner. The pan perimeters...
Replies
5
Views
148
Creating content since 2001. Untold Media.

Newest Plumbing Threads

Back
Top
AdBlock Detected

We get it, advertisements are annoying!

Sure, ad-blocking software does a great job at blocking ads, but it also blocks useful features of our website. For the best site experience please disable your AdBlocker.

I've Disabled AdBlock