Search the forum,

Discuss Another freebie in the Plumbing Jobs | The Job-board area at PlumbersForums.net

Status
Not open for further replies.

stani

Esteemed
Plumber
Gas Engineer
Subscribed
Messages
2,505
Not sure, but went into plumbfix today and was given a new insulated mug, went on the bill as £4-99 then discounted by £4-99
image.jpg
 
I thought you had put something a little stronger in your new cup Stani ...lol regards Turnpin:17:
 
says screwfix on the mug, get on with you, your not allowed in plumfix are you? :)
 
says screwfix on the mug, get on with you, your not allowed in plumfix are you? :)

Read this at 6am, thought I will leave it till later so I could think of a lyrical reply, can't think of a damn thing, but I will lame, I will.
P.s. Well done on 13k.
Stani.
 
Ive still got two of these from the last time they gave them out, they need a big rubber o ring in the lid otherwise they spill everywhere
 
Status
Not open for further replies.

Reply to Another freebie in the Plumbing Jobs | The Job-board area at PlumbersForums.net

Similar plumbing topics

Hello all, I'm would like to extend an existing outside tap to another point in the garden. I'm about to pour a concrete patio and was hoping to run the water line underneath. There are existing drain (and who knows what) pipes running along the same wall so I'm nervous about digging too far...
Replies
6
Views
231
Hi guys. I'm trying to identify a toilet model before ordering a seat for a customer. I went to what used to be a Roca stockist (they no longer are) and one of the guys there reckoned it might be "The Gap". I went to the new stockist and the guy there disagreed it was "The Gap" and that he'd...
Replies
2
Views
140
Hi All I have a leak coming from within my Mira Elite QT shower. It seems to be flowing from behind the switching Control. Any ideas what could be causing this leak. Already Changed the Pump Elbow as one of the clips had popped which was causing a second small leak, Any idea? Is it time to buy...
Replies
0
Views
234
Hi everyone, Looking for a bit of advice, recently went to a job where heating was operating when called for however not for the hot water. I have changed the 3 port actuator Honeywell head however this doesn’t seem to have solved the issue, does this mean that the programmer is faulty? Or is...
Replies
8
Views
292
Hi all, this is probably a daft question but I need to run my cold feed from one side of my wall mounted boiler to the other. Running it beneath the boiler is difficult with lots of obstacles, is it okay if I run soldered copper over / across the top of the boiler? It'll be about 4" off the top...
Replies
1
Views
48
Creating content since 2001. Untold Media.

Newest Plumbing Threads

Back
Top
AdBlock Detected

We get it, advertisements are annoying!

Sure, ad-blocking software does a great job at blocking ads, but it also blocks useful features of our website. For the best site experience please disable your AdBlocker.

I've Disabled AdBlock