Angle grinder advice please

[SimonG]

Or you can get a spanner on the wing nut. I find it moves or snaps. If that fails then its grinder time. About time these were mad of stainless.

 

[rocketmanbkk]

Hello Steve

Just looking now, I think I'll buy tomorrow, I am sure I'll use it again.

Cheers for this and everyone for assistance again.

 

[PlumbBobBob]

they do come in handy for loads of different things and that is a good offer

 

[rocketmanbkk]

how about one of these?
[h=1]Bosch Bi-Metal Plunge Cutting Blade[/h]EAN: 3165140523349
Only £8.98

From B&Q

 

[PlumbBobBob]

you'll get sore fingers using that without the multimaster doing the work

 

[SimonJohns]

i have all makita tools and i have the makita 18v lxt grinder

one of the best tools ive ever bought

use it to cut copper, cut flues, remove old pipework, remove cisterns, cut absolutly everything

10/10 imo

 

[Mike Jackson]

I'd use a dremmel with a small cutting blade in this instance. They're great for cutting things out in small spaces.

 

[scotty plumber]

The only tool's you need for cutting through a rusted c/c kit is a hacksaw and perseverance!

 

[scotty plumber]

The only tool's you need for cutting through a rusted c/c kit is a hacksaw and perseverance!

Also a towel for wiping the sweat off your forehead!

 

[Billy Bob Bob]

never failed with a hacksaw either cut halfway though the bolt and snap off with your grips or cut though the wing nut and prise off