You are using an out of date browser. It may not display this or other websites correctly. You should upgrade or use an alternative browser.
waste
WASTE is a peer-to-peer and friend-to-friend protocol and software application developed by Justin Frankel at Nullsoft in 2003 that features instant messaging, chat rooms, and file browsing/sharing capabilities. The name WASTE is a reference to Thomas Pynchon's novel The Crying of Lot 49. In the novel, W.A.S.T.E. is (among other things) an underground postal service.
In 2003, less than 24 hours after its release, WASTE was removed from distribution by AOL, Nullsoft's parent company. The original page was replaced with a statement claiming that the posting of the software was unauthorized and that no lawful rights to it were held by anyone who had downloaded it, in spite of the original claim that the software was released under the terms of the GNU General Public License.
Several developers have modified and upgraded the WASTE client and protocol. The SourceForge edition is considered by many to be the official development branch, but there are several forks.
Hello,
I would very much appreciate some help/feedback on what I am proposing for my very small ensuite bathroom. While refurbishing it I’m proposing to add a shower. It’s just 1.2m x 1.6m. I have seen similar posts to this on the forum but not quite my situation.
I am proposing to run one...
Hi all,
We are replacing our bathroom “hand wash basin on a table” with a basin on a new wall-hung cabinet with a drawer in it. The problem is, the waste pipe outside diameter is 36mm but the space behind the drawer is only 33mm Behind that gap is a 10mm wide strip of wood (about 30mm high)...
Parents have had a steel beam put into their hallway ceiling to adequately support landing and stairs.
This means that the waste from a sink and shower will need to be reinstated slightly lower into the soil pipe, as the pipes will now run under rather than through the beams (the joists will be...
Hi all, I am hoping someone can advise on this.....bought a 1.5 bowl sink a while ago from B&Q but never got around to fitting it.
Now decided to fit it in my utility room but upon having a look at it the smaller of the two bowls appears to have a rectangular slotted waste exit in the bottom as...
Can anyone suggest a compatible overflow waste that works with this Bath? Appleby Roll Top (freestanding) see link below.
I don’t want to fit an exposed chrome Roll top type overflow that is often suggested . They are pricey for a start. Just require a simple standard one with Flexi tube and...
Hello all,
We hope you are well.
We are looking for some drainage advice on a relatively new build property. The drain outside of the property constantly blocks with toilet paper and waste every 5-6 weeks of use.
Following the blockage we unblock by using hot water and essentially poking...
Hello, have a 4m run of 50mm pipe for the shower. The layout of joists, closeness of corner walls etc mean that it would be very helpful to be able to add the basin waste to a swept tee in the shower waste and this could be between 300-800mm from the soil stack . I've read elsewhere very mixed...
Hi
So I am adding an en-suite to a downstairs bedroom and have to install a macerator. I will be using the SaniPlus Up.
I was trying to get a professional macerator fitter but can't get anyone in the time frame (in the next 10 days) so I am trying to fit the waste piping from the macerator...
Hi Everyone,
Can anyone tell me what's the best way to fix this leaky connection union?
Does the connection to the main down pipe need to be horizontal? Looks a bit dodgy to me.
Should I replace with the pipe layout with something like I have sketched with the red or green lines in the...
I have a 40 mm resin tray to install (sand/cement over suspended ground floor) and a decent McAlpine 90 mm waste. The hole in the tray is apparently on the built-in fall by accident or design, so that, with the ground-flat base, the edges of the hole vary from about 4 mm to about 8 mm on either...
Is it OK to combine osma, polypipe and floplast push fit waste pipe? I. E polypipe fittings and floplast pipe. Different merchants sell just one of the above. So I tend to end up with bits from different manufacturers. I presume its OK. I'm sure I have before and never had any issues. Just...
currently working on my bathroom refurb and am after some advice on how best to go about re arranging the following:
Starting from the top:
The sink waste is solvent welded but i can reuse it in its current position
I want to move the toilet to the adjacent wall so id need to move the...
Hi
Could anybody explain this waste box under a bath,
being honest I have never seen one of these before
the waste from the bath goes in & out of this box then into a soil stack but has no power to it so it is not pumping the waste away?
can anyone explain this?
posted up on here back in October about the waste pipe on a flat Ive got rented out being blocked....
That branch goes into a vertical stack, shared by the flat above and below.
Back in october i had dyno rod take a look at it and they said the pipe was scaled up.
They cleaned out the pipe...
I ordered a McAlpine 90mm x 50mm shower trap for my walk-in shower. The base will be 18mm ply with the shower tray bedded in mortar on top. I don't think the threads of the top half of the trap are going to reach the threads of the bottom half when I assemble everything. I really need more...
Hi,
I bought a new bath overflow and waste which I thought would be simple to install.
The existing seems to have been plumbed differently. Does any one know the connection I need in the second photo?
I had to cut the old overflow off as it wouldn't loosen.
Hi all
was wondering firstly does the bath waste have to have silicone applied to washers ?
when I’ve set up in past I’ve never used it and washers alone done the job.
if silicone is recommended can I use normal bathroom silicone to do the job or would it have to be plumbers gold ?.
Hi I am trying to figure out my bathroom sink waste problem
Renovating the bathroom and the wife wants the sink the opposite side of the room. The stack is in the opposite corner the only way I can get to it is through 2 joists that have already been cut for the old shower waste.
If I do this my...
I am having a house built and I want to provide capped hot/cold water and waste water to a bedroom for a future ensuite.
I don't want the builder to do the ensuite now because I am already over budget.
They are saying they can't provide capped water and waste points to a non-wet area (i.e. a...
Sure, ad-blocking software does a great job at blocking ads, but it also blocks useful features of our website. For the best site experience please disable your AdBlocker.