G
gasmansam
Hi guys, I changed a pcb on an ideal logic 30 as it was stuck on l2 fault, after testing and getting no power at gas valve. I got it all going fine, apart from on hw. When you run the tap nothing registers on the boiler, I took the turnine out and checked it was moving freely, but im not really familiar with this style of the hw side. Is there anything I could of done whilst changing the PCB or is it just going to be the clip in microswitch that sits on top of the turbine? I have checked all the connections on the pcb are clean and ok.
Thanks in advance
Thanks in advance