Search the forum,

hey

Post new thread
  • Thread starter Lee John
  • Start date
  • Replies 4
  • Views 2K

Discuss hey in the Plumbing Jobs | The Job-board area at PlumbersForums.net

Status
Not open for further replies.
L

Lee John

Hey I'm new here, looking for some advice I need a small overflow connector to fit a 17mm dia hole, any specific size I need? Has to be plastic since its being used on glass
 
Is this for a fish tank?

What size pipe are you planning to connect to it?
 
yes it is I am planning to connect them all up to 1" eventually just need a fitting for the 17mm hole, its a drip system for barracks I know the rest just need a connector size, cheers
 
You'd be best off going to an aquarium supplies place for that sort of size in plastic.
 
Status
Not open for further replies.

Reply to hey in the Plumbing Jobs | The Job-board area at PlumbersForums.net

Similar plumbing topics

B
What is correct toilet supply line
Hi. I need a new toilet supply line but donā€™t know the size type of the fitting at the shut off valve. It is not 3/8 compression. It is a plastic nut about the same size as the one going into the cistern but has a different thread. Attached is a photo. Can you advise. Thanks.
Replies
2
Views
209
ShaunCorbs
ShaunCorbs
dreikher
Hole in copper pipe, solder under floor, T coupling & protection
I was stupid enough not to check the position of the pipes under the tiles when installing a toilet and drilled right through the center of a 16 mm copper water pipe. I exposed the pipe by removing a ~30cm section of the plastic sleeve and a ~10 cm section of the pipe around the hole. Several...
Replies
0
Views
216
dreikher
dreikher
T
22mm MDPE connection
I want to reconnect some outbuildings to an existing water supply. The supply pipe is old 22mm MDPE and buried for a fair distance so not going to dig it up and replace it šŸ˜¬. Question is can I use normal 22mm plumbing push-fit connectors to make the connection as finding 22mm MDPE fittings...
Replies
1
Views
291
ShaunCorbs
ShaunCorbs
S
Advice needed for a mixer Spray for kitchen ?
Hello plumbers in my internet. So the Mrs want a spray mixer tap in the kitchen as we had two separate taps. I changed the tap for a temporary two hole mixer but the cold water pressure is high mains fed and the hot is low pressure immersion tank fed. I've been trying to find info on what I...
Replies
2
Views
170
Lou
Lou
johndave
Outdoor stopcock doesn't fully close
Hi all I'm hoping someone can shine a light on this for me Since our stop tap on the pavement has now been filled with sand for whatever reason, we are relying on our property fitted stopcock (this is outside on our garage wall) Unfortunately turning this to the closed position only reduces...
Replies
3
Views
292
exedon2
exedon2
Creating content since 2001. Untold Media.

Newest Plumbing Threads

Electrical Forum
DIY Talk
Tiling Forum
Contractor Advice Forum
Tiling Tools
Back
Top
AdBlock Detected

We get it, advertisements are annoying!

Sure, ad-blocking software does a great job at blocking ads, but it also blocks useful features of our website. For the best site experience please disable your AdBlocker.

I've Disabled AdBlock