I have a conventional heating system. Gas boiler with radiators and a hot cylinder. Heating has a single thermostat in the hall and the water, a thermostat on the cylinder. There are two zone valves (Drayton ZA5), one for the hot water and one for the radiators.
The problem is that the hot...
Hi,
Can someone please explain to me why I have only one tank in the loft. I thought there was always a second smaller F E tank that supplies the rads. It appears the one tank in my loft supplies both the taps & the central heating via the cylinder in the airing cupboard. Is this right ...
Good afternoon Guy's & Girl's,
So I have a Baxi 630i that is showing a e133 fault. Upon hours of extensive research it is an ignition fault that can be caused by numerous of issues.
One being that the condensate pipe is frozen, given the current weather and climate I edged my bets on this...
Had a quote for a new boiler installation. Quote said...
Power Flush require and install new boiler,
====
After the boiler was started, it was making horrible noises
==
I mentioned this and sent an audio recording to the company.
====
Said that is normal boiler noise even though it shakes the...
Hello all!
We recently had a Vaillant ecoTEC plus 832 installed, along with a Vaillant VRT 350f controller! I use Auto mode, and set the programme to come on every day at 6am and switch off at 11pm, and I turned the set back temp down to 5°C (can't we just have an OFF?). The controller sits in...
Hope someone can advise as to my next step. The initial problem was the boiler would go over pressure and blow off, hence resulting in the pressure showing <0. Called heating engineer who diagnosed a pressure release valve problem(prv) so replaced that, again, it went over pressure next...
Morning Ladies and Gents,
I'm after a bit of guidance regarding the Nest thermostat 3rd Generation please...
My heating system is a Glow worm 18hx system boiler. I have a hot water cylinder pump, only radiators all round, mid position valve, Y plan wiring centre.
So my issue... my old...
Hi Guys,
I have a heat only boiler with two tanks in the loft. I have recently drained the system and since then i am not getting any hot water. The hot water tank front two pipes are hot, however the one coming out the top is cold.
Radiators are heating up completely fine.
Hot water taps...
Hi I have a ideal logic 35 combi boiler is just little over 4 years old in a new build property was great for first few years but since about 2 years maybe it keeps loosing pressure what I top up. Once it lost it but then the filling loop wouldn't fill back up had someone out they said it may be...
Hi All,
Have a peculiar problem with my Gloworm Flexicom 30cx combi boiler, the main heat exchanger is getting red hot and fault coding on overheat even though the boiler and central heating is not on, i shut the boiler down for a while, clear the fault code and it will be fine again for...
Hopefully this is the right forum for my quandry. My heating/hot water boiler is in an outbuilding some 20m from the main house. Currently the boiler gets the signal to switch on via an underground cable. Now this is the problem it is just a
piece of T&E buried about a foot below the surface...
Hello.
I have 2 rooms where I do not spend much time in... one of them is like a storage room. and other is like a room where I keep my wet laundry for drying (leaving window slighlty open all the time).
both of the rooms have gas based heaters (central heating based). to save gas I am...
Hi, any advise would be welcomed.
My boiler has locked out, due, I believe to water overheating. Although the water in the boiler seems to be piping hot, the only water coming from the hot tap is cold. If I let the water cool down over time, the boiler resets ok, but when the water gets hot...
I have a 40 year old Glowworm Hideaway 100.
I have lived in this house for 8 years and it has been faultless, until recently. The pilot light won't stay on.
The boiler has been worked on by a Gas Engineer, but he is stumped and telling me I need a new boiler. I can not afford a new boiler...
My boiler packed up 11am yesterday after 21 years problem free heating.
What happens when I switch it on is:
The fan starts, the boiler then fires up and works for about 2 minutes and then the flames go out but the fan is still running.
If I turn it all off for half and hour it can then be...
Hi i wonder if anybody can help with my query, the only gas appliance i have is a ideal Mexico super cf455 boiler, historically my gas usage was 12kwatts a year it is now double that figure at around 24,000 kwh, the boiler is only on for very short amounts of time as in not left on all...
A simple question, but so far I've not found a definitive answer:-
Some older boilers use a thermostatically controlled pump overrun switch built into the boiler thermostat.
They are generally factory set and not adjustable.
At what temperature should it switch?
I'm specifically referring to...
Hi, I just moved into a house about a month ago and today I noticed a small gap in the tube above the boiler flue. Is this something I need to call an engineer out asap? I guess so but wanted to post just in case people have explanation of this setup.
I poked a tiny tie wrap and it goes all...
Hi guys just installed an oil 25/32 external Worcester Bosch Heatslave External boiler.
I can't get hot water. Central heating is fine. Comfort rf fitted and seems to be working fine. Link wire has not been removed.
The sensor is not registering the dhw lts per minute display.
Any help...
Sure, ad-blocking software does a great job at blocking ads, but it also blocks useful features of our website. For the best site experience please disable your AdBlocker.