Discuss Zurn PRV what is the torque of bell housing screwed to valve body. in the UK Plumbing Forum | Plumbing Advice area at PlumbersForums.net

N

Nik Tribhuvan

Hi, I am not a plumber but want some help finding at what torque at which the PRV's bell housing screwed to the valve body. can the plastic bell housing pop off the main valve body due to pressure or unscrew itself due to prolonged water hammer effect? PRV: Wilkins Zurn NR30 40mm 500kpa
 

Reply to Zurn PRV what is the torque of bell housing screwed to valve body. in the UK Plumbing Forum | Plumbing Advice area at PlumbersForums.net

Similar plumbing topics

I have had a look at previous posts and think I know the answer to this but just before I make it worse could I just check what you think about...
Replies
7
Views
264
Hello, I am seeking some advice, I have a POTTERTON PROMAX 28 COMBI Boiler and I noticed yesterday that the water around the house is no longer...
Replies
4
Views
293
  • Question
Ideal Logic 24, Previous problem was that the hot water was only cold or barely warm if the heating was in use. If heating was off and boiler cold...
Replies
2
Views
229
Our kitchen mixer tap has started dripping. Like so much of the plumbing in our almost new build bungalow, it is lacking! The plumber didn't...
Replies
12
Views
439
Hi all. Hope you have all been keeping well. A while back I decided I only wanted to fit one brand of boiler and decided on Viessmann due to...
Replies
9
Views
340
Back
Top
AdBlock Detected

We get it, advertisements are annoying!

Sure, ad-blocking software does a great job at blocking ads, but it also blocks useful features of our website. For the best site experience please disable your AdBlocker.

I've Disabled AdBlock