Search the forum,

Zurn PRV what is the torque of bell housing screwed to valve body.

Post new thread

Discuss Zurn PRV what is the torque of bell housing screwed to valve body. in the UK Plumbing Forum | Plumbing Advice area at PlumbersForums.net

N

Nik Tribhuvan

Hi, I am not a plumber but want some help finding at what torque at which the PRV's bell housing screwed to the valve body. can the plastic bell housing pop off the main valve body due to pressure or unscrew itself due to prolonged water hammer effect? PRV: Wilkins Zurn NR30 40mm 500kpa
 

Reply to Zurn PRV what is the torque of bell housing screwed to valve body. in the UK Plumbing Forum | Plumbing Advice area at PlumbersForums.net

Similar plumbing topics

N
Towel Rail Valve Advice please (35 Characters needed.)
I have had a look at previous posts and think I know the answer to this but just before I make it worse could I just check what you think about this one. Granddaughter just moved house and this valve decided to leak when it was closed. When open its fine. Normally I have repacked the gland on...
Replies
7
Views
191
Timmy D
T
B
POTTERTON PROMAX 28 COMBI Boiler - Hot Water Issue
Hello, I am seeking some advice, I have a POTTERTON PROMAX 28 COMBI Boiler and I noticed yesterday that the water around the house is no longer warming up. The heat exchanger has been changed 6 months ago, so I do not believe it is that. Does anyone have any ideas on what it could be? Thanks
Replies
4
Views
231
oz-plumber
O
F
  • Question
No Hot water, Fixed and Broken Again Ideal Logic 24
Ideal Logic 24, Previous problem was that the hot water was only cold or barely warm if the heating was in use. If heating was off and boiler cold then would get hot water most of the time. Changing the flow cartridge about 2 years ago (when I moved in) solved this problem enough to suffer it as...
Replies
2
Views
139
Lou
Lou
C
How to identify dripping tap.
Our kitchen mixer tap has started dripping. Like so much of the plumbing in our almost new build bungalow, it is lacking! The plumber didn't install any isolating cocks in the H&C feed to the tap so how can I identify which of the valves is passing? Shut the whole H&C water system down?
Replies
12
Views
338
Timmy D
T
M
Viessmann external flue run conundrum
Hi all. Hope you have all been keeping well. A while back I decided I only wanted to fit one brand of boiler and decided on Viessmann due to space for servicing and changing parts if ever needing to. I am finding my decision rather hard due to the different clearances on flue runs and cupboards...
Replies
9
Views
210
mutley racers
M
Creating content since 2001. Untold Media.

Newest Plumbing Threads

DIY Advice
Tiling Forums
Contractor Advice Forum
Tile Forum
Tiling Advice
Back
Top
AdBlock Detected

We get it, advertisements are annoying!

Sure, ad-blocking software does a great job at blocking ads, but it also blocks useful features of our website. For the best site experience please disable your AdBlocker.

I've Disabled AdBlock