Users can remove all display ads (not sponsors) for a small fee. Click for info (must be logged in)

Discuss Zip heater or whats the alternative? in the Plumbing Jobs | The Job-board area at PlumbersForums.net

Status
Not open for further replies.
M

manx12

Between 30 to 50litre hot water capacity required to feed 5 basins. (only electricity.. no gas)

Do you run the initial hot water feed in 22mm and then branch down to 15mm on each basin?
 
go for heatrae sadia multipoint 30 or 50L its Unvented so its mains fed outlets are 15mm

I fitted a 50L Horizontal model couple of months back and it was around £900, horizontal ones are dearer though.
 
Status
Not open for further replies.

Reply to Zip heater or whats the alternative? in the Plumbing Jobs | The Job-board area at PlumbersForums.net

Similar plumbing topics

Hello plumbers in my internet. So the Mrs want a spray mixer tap in the kitchen as we had two separate taps. I changed the tap for a temporary two...
Replies
2
Views
199
  • Question
Ideal Logic 24, Previous problem was that the hot water was only cold or barely warm if the heating was in use. If heating was off and boiler cold...
Replies
2
Views
196
We run a community village hall and have a large kitchen provided for the use of hirers. This includes a Lincat SLR9 gas cooker which I believe is...
Replies
5
Views
536
I was stupid enough not to check the position of the pipes under the tiles when installing a toilet and drilled right through the center of a 16...
Replies
0
Views
226
We are from Alberta, and I own an electrical company. I have been asked by a BC Mechanical P. Eng. to install an emergency STOP button at the...
Replies
5
Views
312
Back
Top
AdBlock Detected

We get it, advertisements are annoying!

Sure, ad-blocking software does a great job at blocking ads, but it also blocks useful features of our website. For the best site experience please disable your AdBlocker.

I've Disabled AdBlock