Discuss vaillant ecotec plus 837 rapid pressure loss in the Plumbing Jobs | The Job-board area at PlumbersForums.net

Status
Not open for further replies.
B

bigbird

I have had my vaillant for 5 years. It was serviced after first year and again this year .
For the past month i have had to top pressure up at least once a week. This last week i have done it daily.
After i had it serviced last week, the engineer said i must have a leak beneath ground level.

After he left i didnt need to top the pressure up for aporox 4 days.

Since then its been daily again.

There is no evidence of leakage anywhere in property.

I have topped the expansion vessal up to 0.9 bar.

Pressure still dropping.

Now when i top pressure up the reading increases from 0.3 bar to 1.2 bar in approx 5 seconds.

I am wondering if this problem is sensor related ??


Can anyone please help ?
 
Is the pipe outside, the one that's bent back to the wall passing water?
 
ive changed quite a few expansion vessals on newish vaillants, like above is that dripping.
 
There is no signs of water leaking from inside of boiler nor from pressure relief or overflow.
 
Sounds like a leak under the floor then if you can't see any obvious signs of water anywhere
 
There has to be some kind of leakage for the pressure to drop.like above hidden pipes or could be a problem inside the boiler which a gsr engineer could check for you.
 
Last edited by a moderator:
The only reason i dont agree is that the pressure held for a long time after service , but has since dropped more rapidly. This inconsistency in pressure drop and time fluctuates.
 
the water/pressures going somewhere unless its air venting which i doubt. does it fluctuate depending on heating demand or just randomly when the boilers not even on..?
 
Could there be a pressure sensor problem ?

if its an analouge dial thats shows low pressure then no, the usual pressure sensor fault in vaillants is when it goes to f75 and it cant sense the pump running because the sensors blocked. which is gsr job.
 
Status
Not open for further replies.

Reply to vaillant ecotec plus 837 rapid pressure loss in the Plumbing Jobs | The Job-board area at PlumbersForums.net

Similar plumbing topics

Every two weeks or so I have to go and top up the system because the hot taps are running cold. Boiler display is flashing 0.6 bar and I fill up...
Replies
2
Views
293
PSxxxxxx
P
  • Question
Ideal Logic 24, Previous problem was that the hot water was only cold or barely warm if the heating was in use. If heating was off and boiler cold...
Replies
2
Views
227
Hi, Can anyone advise as to why the cold water to my bathroom keeps airlocking? This originally happened about 12 months ago and has happened 3-4...
Replies
9
Views
465
Hello all, I’m replacing a concrete paving slab patio in the back yard. The original patio used 50mm deep concrete slabs on hardcore & sand. I’m...
Replies
6
Views
326
Back
Top
AdBlock Detected

We get it, advertisements are annoying!

Sure, ad-blocking software does a great job at blocking ads, but it also blocks useful features of our website. For the best site experience please disable your AdBlocker.

I've Disabled AdBlock