USA Unvented cylinder - water pressure

[Scott_D]

Was just thinking that. Would have to remove eaves plasterboard wall

You are going to need to get an Independant report done I think
How much money are you withholding?
Will it cover major work?

 

[Riley]

Get in quick if they are going under as you say, you need to be a party of interest

 

[Riley]

what’s the rest of the install like dare I ask

 

[Tim0212]

Landmark lofts are the loft firm and landmark heating managed the cylinder installation. I dont think landmark heating are in trouble but think landmark lofts are. So incoming goes straight through house and under kitchen tiles. This and feed to cylinder(once correct) would all need to be replaced to get a good flow? The loft firms "engineer" that scoped the job and did pressure and flow tests never mentioned anything about incoming.

 

[Tim0212]

what’s the rest of the install like dare I ask

Are there other photos that would help with this?

 

[Riley]

Well he clearly wasn’t qualified. He should as a minimum have tested static and dynamic pressure as well as lpm did he do any tests or just turn on a tap and say ooh that’s good

 

[Riley]

Are there other photos that would help with this?

Well if they’ve installed a potential bomb like that one would be remiss not to ask about the rest of it

 

[Tim0212]

Im not sure of tests. He just said 22lpm and 3bar

 

[Riley]

So he’s plucked figures out of thin air?

 

[ShaunCorbs]

Easy way to test from the kitchen sink fill a 1l bottle and time it