Search the forum,

Talon double pipe covers

Post new thread

Discuss Talon double pipe covers in the DIY Plumbing Forum area at PlumbersForums.net

S

Stratf01

Messages
42
Does anyone know if the 15mm Talon double pipe cover with inside corner will accommodate 90 degree copper pipe bends?

In other words will the corner cover the curve of the 90 degree bend or do I need to use joints here?

Thank you
 
You can put pulled 90s in them
 

Reply to Talon double pipe covers in the DIY Plumbing Forum area at PlumbersForums.net

Similar plumbing topics

W
Outdoor Tap at Porch
Hi, basic question, any insight much appreciated. Looking to have an outdoor tap in my front porch fed from 15mm pex coming up from suspended floor. Pic 1 is inside porch, pex temporarily clipped to give an idea of pipe placement (ignore shoddy blockwork of booted cowboy builder!), Pic 2 is...
Replies
6
Views
241
Dave Moore
D
D
Extending outdoor tap and drain
Hello all, I'm would like to extend an existing outside tap to another point in the garden. I'm about to pour a concrete patio and was hoping to run the water line underneath. There are existing drain (and who knows what) pipes running along the same wall so I'm nervous about digging too far...
Replies
6
Views
233
DIwhYdidIstartThis
D
T
22mm MDPE connection
I want to reconnect some outbuildings to an existing water supply. The supply pipe is old 22mm MDPE and buried for a fair distance so not going to dig it up and replace it 😬. Question is can I use normal 22mm plumbing push-fit connectors to make the connection as finding 22mm MDPE fittings...
Replies
1
Views
273
ShaunCorbs
ShaunCorbs
dreikher
Hole in copper pipe, solder under floor, T coupling & protection
I was stupid enough not to check the position of the pipes under the tiles when installing a toilet and drilled right through the center of a 16 mm copper water pipe. I exposed the pipe by removing a ~30cm section of the plastic sleeve and a ~10 cm section of the pipe around the hole. Several...
Replies
0
Views
192
dreikher
dreikher
A
copper vs pushfit pipes
Copper pipes, I think its fair to say, is not what it used to be, the copper is getting thin while the cost is going up. Meanwhile, plastic Pushfit seems to be getting better and better, cost and convenience was always better, but now the quality is to, have we reached a stage where plastic will...
Replies
2
Views
258
Chuck
C
Creating content since 2001. Untold Media.

Newest Plumbing Threads

Electrical Blog
Tiling Tools
Plumbers Forum - Plumbing Advice
Electrical News
Tile Advice
Back
Top
AdBlock Detected

We get it, advertisements are annoying!

Sure, ad-blocking software does a great job at blocking ads, but it also blocks useful features of our website. For the best site experience please disable your AdBlocker.

I've Disabled AdBlock