stupid question time

[jldplumb]

just thought check here before doing it.. Can I solder hard regular copper onto soft copper tap tails with endfeed fittings without any problems? hopin for speedy replies as they're fluxed up and ready to go!

 

[SimonG]

Fill yer boots.

 

[clarky101]

Yep no problem

 

[kris]

Theres no such thing as a silly question ,,, lol

 

[Dsp]

Only daft question is the one you don't ask

 

[joni os]

The temper of the person doing the work effects the outcome, not the parts being joined.

 

[PlumbBobBob]

The temper of the person doing the work effects the outcome, not the parts being joined.

very deep for a Saturday Joni

 

[stevetheplumber]

just put a wet rag above to stop the heat rising up to the o rings idealy they should be a demountable fitting but i suspect youve cut the ends of a paper thin set

 

[AWheating]

you should always solder these tails imo, to soft for compression and pushfit alot of the time. sometimes i cut them back 3 inches solder couplers on with alittle pipe and then compression or pushfit if needed.