Search the forum,

Discuss Shower frame finishing panel in the Plumbing Jobs | The Job-board area at PlumbersForums.net

DuncanM

Gas Engineer
Messages
122
Hi. Thanks for looking. Usually tile or wet wall the frame. This time though it's an quadrant tray. Would a glazing supplies company have something to wrap around the frame to finish it or is there a better place?
 
As above 100 mm upvc trim fixed to timber battens with screws and white caps is what I use
 

Attachments

  • IMG_20191007_165113.jpg
    IMG_20191007_165113.jpg
    97.2 KB · Views: 16
  • IMG_20191007_164626.jpg
    IMG_20191007_164626.jpg
    97.8 KB · Views: 17
I have a plastic centre just up the road, good for all types of upvc trims. Amazing what they have in there. As KOP says either screws and white caps or puck up a box of stainless plastic headed nails from the same place. Prefer the screws and caps as easier to get back of later if required.
 

Reply to Shower frame finishing panel in the Plumbing Jobs | The Job-board area at PlumbersForums.net

Similar plumbing topics

Hi All I have a leak coming from within my Mira Elite QT shower. It seems to be flowing from behind the switching Control. Any ideas what could be causing this leak. Already Changed the Pump Elbow as one of the clips had popped which was causing a second small leak, Any idea? Is it time to buy...
Replies
0
Views
234
Hi all, I'm installing a concrete patio out back. By the wall under the kitchen sink I have an existing P-Trap gully for the grey water from the sink, dishwasher, washing machine etc. When I pour the concrete there won't be any chance to dig it up anymore. From my own research I get the...
Replies
0
Views
122
Hi, basic question, any insight much appreciated. Looking to have an outdoor tap in my front porch fed from 15mm pex coming up from suspended floor. Pic 1 is inside porch, pex temporarily clipped to give an idea of pipe placement (ignore shoddy blockwork of booted cowboy builder!), Pic 2 is...
Replies
6
Views
234
Copper pipes, I think its fair to say, is not what it used to be, the copper is getting thin while the cost is going up. Meanwhile, plastic Pushfit seems to be getting better and better, cost and convenience was always better, but now the quality is to, have we reached a stage where plastic will...
Replies
2
Views
253
Hello plumbers in my internet. So the Mrs want a spray mixer tap in the kitchen as we had two separate taps. I changed the tap for a temporary two hole mixer but the cold water pressure is high mains fed and the hot is low pressure immersion tank fed. I've been trying to find info on what I...
Replies
2
Views
140
Creating content since 2001. Untold Media.

Newest Plumbing Threads

Back
Top
AdBlock Detected

We get it, advertisements are annoying!

Sure, ad-blocking software does a great job at blocking ads, but it also blocks useful features of our website. For the best site experience please disable your AdBlocker.

I've Disabled AdBlock