Search the forum,

Discuss Seeking experience around the north east area in the Plumbing Jobs | The Job-board area at PlumbersForums.net

Status
Not open for further replies.
D

DaveyL88

Hi my name is David I'm 27 and looking for some experience with in plumbing, I am attending college studying level 2 6035 twice a week on evenings and it's all going well, pay is not an issue at the moment as I value knowledge and experience over anything else, I have a driving licence and car, i am very punctual and have a good attitude.
thanks for any help kind regards David
 
Welcome to the forum David, might help to say where you live rather than North east area and if you are available Mon - Fri. Good luck in your quest.
 
Aye, narrow it down a bit, big spot the north east :) Good luck.
 
Re: Seeking experience around the Tyne and Wear area Sunderland Newcastle Durham

Hi my name is David I'm 27 and looking for some experience with in plumbing, I am attending college studying level 2 6035 twice a week on evenings and it's all going well, i also hold a CSCS card, pay is not a big issue at the moment as I value knowledge and experience over anything else,I live in houghton le spring and am willing to travel as i have a driving licence and car, i am very punctual and have a good attitude.
thanks for any help kind regards David
 
Aye, narrow it down a bit, big spot the north east :) Good luck.

Is it?

I thought it was Cheryl Cole?

map2.jpg
 

Attachments

  • map.jpg
    map.jpg
    3.8 KB · Views: 49
Thank you for posting this opportunity for our members.

If this interests you, please pm the op direct.
 
Status
Not open for further replies.

Reply to Seeking experience around the north east area in the Plumbing Jobs | The Job-board area at PlumbersForums.net

Similar plumbing topics

Every two weeks or so I have to go and top up the system because the hot taps are running cold. Boiler display is flashing 0.6 bar and I fill up to 1.3. I've had an engineer look inside the boiler and he can't see anything wrong. I've checked the pipes all over the house and cannot see any...
Replies
1
Views
133
I was stupid enough not to check the position of the pipes under the tiles when installing a toilet and drilled right through the center of a 16 mm copper water pipe. I exposed the pipe by removing a ~30cm section of the plastic sleeve and a ~10 cm section of the pipe around the hole. Several...
Replies
0
Views
187
Hi all. Hope you have all been keeping well. A while back I decided I only wanted to fit one brand of boiler and decided on Viessmann due to space for servicing and changing parts if ever needing to. I am finding my decision rather hard due to the different clearances on flue runs and cupboards...
Replies
9
Views
195
  • Question
Ideal Logic 24, Previous problem was that the hot water was only cold or barely warm if the heating was in use. If heating was off and boiler cold then would get hot water most of the time. Changing the flow cartridge about 2 years ago (when I moved in) solved this problem enough to suffer it as...
Replies
2
Views
127
B
Hi, I've followed this excellent forum for several years but have never posted, so decided I'd better give some details. My status is the upper end of DIY and I've a couple of house renovations under my belt (my own homes) I am retired but do volunteer handyman jobs for the elderly. Not...
Replies
0
Views
36
B
Creating content since 2001. Untold Media.

Newest Plumbing Threads

Back
Top
AdBlock Detected

We get it, advertisements are annoying!

Sure, ad-blocking software does a great job at blocking ads, but it also blocks useful features of our website. For the best site experience please disable your AdBlocker.

I've Disabled AdBlock