Search the forum,

Discuss Pipe slices for stainless in the Plumbing Jobs | The Job-board area at PlumbersForums.net

Status
Not open for further replies.

ih1

Gas Engineer
Messages
68
Iv been fitting heating in a area where all the houses have stainless pipe. Does any one have pipe slices for stainless? I'm getting fed up using a hacksaw
 
I've never seen "pipeslices" for stainless but you can buy small normal wheelcutters. I've got ridgid ones in 6-67mm and some smaller 2-28mm and they munch stainless and crimp carbon steel easy
 
Status
Not open for further replies.

Reply to Pipe slices for stainless in the Plumbing Jobs | The Job-board area at PlumbersForums.net

Similar plumbing topics

D
Pipes for thermostat shower have been fitted at different heights. Any way of rectifying without ripping all tiles. So for clarity 15mm pipes sunk into wall behind bath. Walls have fresh tiles. Have realised as about to fit shower these pipes one is set higher than the other. If you fit a...
Replies
2
Views
218
Copper pipes, I think its fair to say, is not what it used to be, the copper is getting thin while the cost is going up. Meanwhile, plastic Pushfit seems to be getting better and better, cost and convenience was always better, but now the quality is to, have we reached a stage where plastic will...
Replies
2
Views
280
P
  • Question
Boiler is SIRIUS THREE FS 70 Potterton commercial. Situation: We are small building contractors and my labourers managed to damage the radiator pipes during the strip out. Not the end of the world as damages happens. I am responsible builder and paying my bills and to repair the damages if...
Replies
2
Views
57
Hello all, I’m replacing a concrete paving slab patio in the back yard. The original patio used 50mm deep concrete slabs on hardcore & sand. I’m planning to pour a 100mm deep concrete patio on 100mm hardcore. In order to achieve the same final height to line up with the rest of the patio, I...
Replies
6
Views
273
Hello, I am seeking some advice, I have a POTTERTON PROMAX 28 COMBI Boiler and I noticed yesterday that the water around the house is no longer warming up. The heat exchanger has been changed 6 months ago, so I do not believe it is that. Does anyone have any ideas on what it could be? Thanks
Replies
4
Views
265
Creating content since 2001. Untold Media.

Newest Plumbing Threads

Back
Top
AdBlock Detected

We get it, advertisements are annoying!

Sure, ad-blocking software does a great job at blocking ads, but it also blocks useful features of our website. For the best site experience please disable your AdBlocker.

I've Disabled AdBlock