Search the forum,

Discuss Olci in the Plumbing Jobs | The Job-board area at PlumbersForums.net

Status
Not open for further replies.

helpsy

Plumbers Arms member
Plumber
Gas Engineer
Messages
1,754
Paid £2990 for a gas course with OLCI in March and been chasing and chasing and getting fed up with it, think I want my money back. I believe their advertising is not true. Signed up to do course in Bristol as advertised....been asked if I could do it in Cardiff....so drive past Bristol centre with extra fuel, bridge money and hours travelling a day. Get real you advertise the course in Bristol....if you don't have dates don't advertise it....I'm sure that's what the advertising standards would say !!!!!
 
i had problems with all paperwork side of things from start to finish tutors at newcastle where brill but pulling there hair out with the clowns running the show in london.
 
shame to hear about your troubles helpsy i did most of my training at the livingston centre and it actually went pritty smooth.
 
My training has been brilliant, but as mentioned the staff in London are better fitted in working for a circus!
 
Hope you got something free, I keep getting offered cheap courses and free unvented and water regs from OLCI but I stuck to my guns and went to college, cost me £2000 and everything has gone smoothly
 
the tutors were spot on i agree with you there mate. i had a guy called glen. top bloke.
 
Status
Not open for further replies.

Reply to Olci in the Plumbing Jobs | The Job-board area at PlumbersForums.net

Similar plumbing topics

We run a community village hall and have a large kitchen provided for the use of hirers. This includes a Lincat SLR9 gas cooker which I believe is a 23.8Kw appliance with all six burners and oven on max. This was installed some 10 years ago and has passed all subsequent Gas Safety inspections as...
Replies
5
Views
496
Copper pipes, I think its fair to say, is not what it used to be, the copper is getting thin while the cost is going up. Meanwhile, plastic Pushfit seems to be getting better and better, cost and convenience was always better, but now the quality is to, have we reached a stage where plastic will...
Replies
2
Views
270
I was stupid enough not to check the position of the pipes under the tiles when installing a toilet and drilled right through the center of a 16 mm copper water pipe. I exposed the pipe by removing a ~30cm section of the plastic sleeve and a ~10 cm section of the pipe around the hole. Several...
Replies
0
Views
208
Creating content since 2001. Untold Media.

Newest Plumbing Threads

Back
Top
AdBlock Detected

We get it, advertisements are annoying!

Sure, ad-blocking software does a great job at blocking ads, but it also blocks useful features of our website. For the best site experience please disable your AdBlocker.

I've Disabled AdBlock