J
jjclancaster
Hi folks, wondering what people use to measure oil flow can't find any manual measuring equipment?
Discuss oil flow rate measurement in the Plumbing Jobs | The Job-board area at PlumbersForums.net
- Status
- Messages
- 4,817
Measuring flow for what reason ?
J
jjclancaster
To measure the flow of oil to an appliance.
- Messages
- 941
A fuel meter can be put on d line
- Messages
- 4,817
I realise it's for measuring flow but why do you need that ?
I'm only curious because I have worked on oil for a long time and never needed one.
I'm only curious because I have worked on oil for a long time and never needed one.
- Messages
- 4,817
I realise it's for measuring flow but why do you need that ?
I'm only curious because I have worked on oil for a long time and never needed one.
I'm only curious because I have worked on oil for a long time and never needed one.
- Messages
- 367
are you asking just so you can fill in that space in the form ?
I usually just look at the MI's, the info is often in that table with the nozzle and CO2 readings etc, it will have an oil flow rate for each pressure/nozzle setup.
I usually just look at the MI's, the info is often in that table with the nozzle and CO2 readings etc, it will have an oil flow rate for each pressure/nozzle setup.
- Status
Reply to oil flow rate measurement in the Plumbing Jobs | The Job-board area at PlumbersForums.net
Similar plumbing topics
Hello plumbers in my internet. So the Mrs want a spray mixer tap in the kitchen as we had two separate taps. I changed the tap for a temporary two...
- Question
Ideal Logic 24, Previous problem was that the hot water was only cold or barely warm if the heating was in use. If heating was off and boiler cold...
Hi All
I have a leak coming from within my Mira Elite QT shower. It seems to be flowing from behind the switching Control. Any ideas what could...
Hi all I'm hoping someone can shine a light on this for me
Since our stop tap on the pavement has now been filled with sand for whatever reason...
We are from Alberta, and I own an electrical company.
I have been asked by a BC Mechanical P. Eng. to install an emergency STOP button at the...
Creating content since 2001. Untold Media.