G
gates1979
I am fitting a new monobloc tap to my kitchen sink and was wondering is the hole for the tap a standard size or do they vary
Last edited by a moderator:
Discuss kitchen sink tap holes in the Plumbing Jobs | The Job-board area at PlumbersForums.net
Reply to kitchen sink tap holes in the Plumbing Jobs | The Job-board area at PlumbersForums.net
Similar plumbing topics
Hello plumbers in my internet. So the Mrs want a spray mixer tap in the kitchen as we had two separate taps. I changed the tap for a temporary two...
Hi
I have a kitchen mixer tap which allows the top part to pull out as a hose (like american sinks).
It has frayed and I need t replace it, can...
I am in process of replacing an existing sink with a new stainless steel one. The existing tap is plumbed directly to copper which means that it...
Good afternoon,
Just looking for some general advise, I'm renovating my kitchen and need to disconnect my kitchen sink pipes while I re-plaster...
I had a plumber fit a new mono block kitchen tap. The water runs very slowly now. Also, not sure if this is to do with it, but my hot water...