Search the forum,

Identity help .

Post new thread

Discuss Identity help . in the Plumbing Jobs | The Job-board area at PlumbersForums.net

quality

quality

Plumbers Arms member
Plumber
Gas Engineer
Messages
4,294
Can any of you folks identify the cylinder/immersion heater in the pics please there no manufacture on the cylinder at all

IMG_8891.PNG


IMG_8892.PNG


IMG_8893.PNG


IMG_8894.PNG


IMG_8895.PNG
 
Okay. Then basically any immersion element of the correct length with the correct boss size (looks like 1.5inch) will do.
Just make sure it has NO copper bits like pockets as they corrode much faster than the incalloy parts.
One should NOT use std immersions on a stainless cylinder.
HTH ;)
 
I was going to recommend contacting The Electric Water Heating company at Harlow I think they only do Internet now they used to have a store in East Ham E13 and were always a great source of info ....glad you got it sorted......regards Turnpin:)
 

Reply to Identity help . in the Plumbing Jobs | The Job-board area at PlumbersForums.net

Similar plumbing topics

jamespipe
Plumber recommendation for heat pump HWS installation
Hi, My current hot water system needs to be replaced. Anyone got any suggestions or can recommend any plumbers around Derrimut area that won't rip me off? An office guy recommended me to apply for government rebates and get it installed through timetosave.com.au. How reliable is this...
Replies
6
Views
301
oz-plumber
O
C
How to identify dripping tap.
Our kitchen mixer tap has started dripping. Like so much of the plumbing in our almost new build bungalow, it is lacking! The plumber didn't install any isolating cocks in the H&C feed to the tap so how can I identify which of the valves is passing? Shut the whole H&C water system down?
Replies
12
Views
339
Timmy D
T
S
Advice needed for a mixer Spray for kitchen ?
Hello plumbers in my internet. So the Mrs want a spray mixer tap in the kitchen as we had two separate taps. I changed the tap for a temporary two hole mixer but the cold water pressure is high mains fed and the hot is low pressure immersion tank fed. I've been trying to find info on what I...
Replies
2
Views
137
Lou
Lou
W
Outdoor Tap at Porch
Hi, basic question, any insight much appreciated. Looking to have an outdoor tap in my front porch fed from 15mm pex coming up from suspended floor. Pic 1 is inside porch, pex temporarily clipped to give an idea of pipe placement (ignore shoddy blockwork of booted cowboy builder!), Pic 2 is...
Replies
6
Views
234
Dave Moore
D
C
Y Plan, no hot water but heating is working when called
Hi everyone, Looking for a bit of advice, recently went to a job where heating was operating when called for however not for the hot water. I have changed the 3 port actuator Honeywell head however this doesn’t seem to have solved the issue, does this mean that the programmer is faulty? Or is...
Replies
8
Views
292
John.g
J
Creating content since 2001. Untold Media.

Newest Plumbing Threads

Tiling Forums UK
Tilers Forum
TilersForums.co.uk | UK Tiling Forum - Est 2006
Tile Advice
Electrical Advice
Back
Top
AdBlock Detected

We get it, advertisements are annoying!

Sure, ad-blocking software does a great job at blocking ads, but it also blocks useful features of our website. For the best site experience please disable your AdBlocker.

I've Disabled AdBlock